Відео

Thanks for subscribing! I’m just using a cheap Scosche BTFM9 FM modulator. It supports hands free calling but I just use it for music. You will get less radio interference if you choose the lowest frequencies 88.1-89.9. Also if you don’t listen to radio, don’t screw in your antenna and you won’t get random interference on long road trips. We bought the dash mat when truck was new in ‘97. I’ll have to see if it still has the manufacturer on it next time I’m in the truck.

@@doctube2020thanks for your reply especially the tip about the antenna removal.

I’ll have to remove the driver side valve cover and see what I can see. Seems top end to me and I’d rather have that than rod knock! Odd it doesn’t happen when cold but once up to temperature you really hear it. Running 10-40 now. Guess I could try a can of engine restore or motor honey to try and quiet it down.

Thanks!

Ha, that exhaust was put on a few years after it was new. It’s close yes but No damage to tire. But that tire is now 27 yeas old!

2016 GM changed GMC backlight from red to blue. Chevrolet was always blue backlight for this generation.

You are correct it could use more rpm before it shifts. New engine max hp is at 5700 rpm. The ol Turbo 350 has the stock shift points but i've been researching that if I grind off some of the govener weights on the trans, that should raise the shift points. When it gets above freezing this spring i'll give that a try and do another video. Cheers

@@doctube2020 yes and an adjustable shift modulator will also help it shift at a higher rpm at lower throttle inputs

I've had a good experience with blackbeartuning. I've noticed a bigger difference with their tune vs a off the shelf tuner you order like hypertech.

Pcmperformance is also a good place to consider. You should do a 0411 pcm swap

I didn’t like black bear in general just speaking with them first and only time there sketch about everything.. what’s your qualms with them?

Thanks! I recently aquired the 03 suburban on my channel with 5.3. I perfer the ol vortec small block for towing my 3500lb enclosed trailer. The 5.7 small block stays in a higher gear longer than the 5.3. The 5.3 doesn't really come alive until high rpm. The 5.7 sbc kind of falls off over 4k rpm but has more torque down low.

Thanks! I didn't hate it without the resonators, was just getting tired of all the chop and harshness at idle and low to mid throttle. The resonators cleaned it up and gave it some manners.

@@doctube2020 yeah it sounds really really good.

Nice! What year? Any other exhaust mods?

@@doctube2020 it’s a 2023 with a MBRP 4in Catback Exhaust.

It’s about the same but I can get 17-18 if I drive 65 on the highway. In theory it should slightly increase mpg since the tune maxes out ignition timing amongst other improvements like less torque management = more power to the wheels.

I've only seen 5.3 Denali's in newer trucks like 2014+.

?

I’ve thought about doing the servo mod but don’t want to kill the original trans with over 218k on it. The tune firmed up the shifts but compared to the newly rebuilt trans in my 03 suburban the high mileage trans in this truck does shift soft.

@@doctube2020 The servo will do the opposite of killing it. The “soft” shifting it does now is what’s wearing it out. The servo will provide better apply pressure, which means there’s less time of “slipping” inside the trans prolonging the life. It doesn’t shift “crazy hard” until like WIDE open if you’re going through the gears. It’s easy to cruise around with too!

@@doctube2020 Yes get a servo 2nd is enough. Do 4th when you rebuild if you ever do. Performance tech btw. I own a 98 with a built 4l60e

Is it ok to tow with a servo? I occasionally tow my enclosed trailer that weighs 3.5 - 4k lbs.

@@doctube2020 Yes be even better because when it shifts it will have more holding power in gears. Aka you can tow more before you burn up transmission clutches. And transmission will also last longer.

This engine cover is from a Yukon xl Denali but you’re right the Escalade has the same engine covers.

Thanks! Nice! Wish I had the 6.0 but the black bear tune really woke up the 5.3. Magnaflow muffler and afe intake helped a bit too but there’s no replacement for displacement! Well, maybe a turbo or supercharger lol. LS engines especially the ones without AFM are super reliable though.

Google GM transfer case pump rub. It’s a well publicized issue but remember GM cranked out Millions of these SUVs and trucks. People come to the internet to complain. Yes it can be an issue but it’s not a guaranteed problem in every one. I have an 03 suburban with 177k on it. No issues with transfer case or front / rear differential. GM used a few different transfer cases and they take different fluid depending on which case you have. The AWD Yukon takes normal Dex/merc ATF. My suburban has a selectable 2hi, 4hi, 4lo and auto mode transfer case. You must use the blue GM fluid for autotrac transfer case. If you’re thinking of buying any used vehicle take it to a trusted mechanic and have them go over the vehicle. If the seller won’t allow this or wants you to use their mechanic that’s a red flag and walk away.

@@doctube2020 thanks for the detailed response, I appreciate it. I had a navy blue ‘01 Silverado 1500 z71 with the 4-button tcase with auto, 2-hi, 4-hi & 4-lo and never had an issue other than the 4l60e starting to slip when moving from a stop towards the end of my ownership of it (had about 180,000). Anyway, I drove it from the twin cities of MN to Wichita, KS, back again & half way back again 6 months later, and a few times in Kansas before selling it, and for a (then) 17+ y/o truck it did pretty darn good, other than an alternator that happened to wait to go out until during my road trip, as well as typical rust (which was actually pretty clean for MN standards). Anyway, long story short, I love these trucks & would love the Denali for light-medium-duty towing. Quadrasteer Sierra/Yukon Denali/Silverado/Suburban would be amazing!

i just had my 05 xl Denali serviced for the pump rub, only had 149k miles when i picked it up

@DURAOBEATS No leak? Just preventative?

@@doctube2020 the transfer case was getting overfilled and the transmission was low

That’s fairly low mileage for an 03. They are great SUV’s!

📊

The 97 k1500 was faster than 79 K10 before I put new blueprint engine in. Now 79 K10 is faster than 97 even with the old 3 speed auto. Of course the 2018 Sierra beats them all with 6.2L and 8 speed auto.

Thanks 👍

Good eye, I remember it going higher than 40psi in the past. I’m going to try a new oil pressure sensor first. I’ll also check the gauge with my odb2 scanner to see if it matches

Update: I replaced the oil pressure sensor and it now shows about 55 - 60 psi at high RPM. The old sensor was accurate when cold oil temps but when warm it wouldn’t go past 40psi. The old sensor broke in half when I removed it but it’s 26 years old.

@@doctube2020Delete the oil cooler lines from the truck off the radiator and remove the housing above the oil filter and bypass it with a melling oil filter adapter !! You’ll gain a ton of oil pressure. They claim you need them lines for towing but it’s subject to opinion everyone deletes them they always end up leaking …. No one’s truck oil is any the bit cooler with them bulky lines in the way , it’s a myth in my opinion. I’ve had great experience bypassing them on all my Chevy. If that was a 2500/3500 series Obs Tow rig then I’d say keep them but I’m a believe in the 1500s there useless

Thanks! Got to love the southwest for rust free vehicles but the sun will bake the paint off. I’ve seen some clean and several well used 88-99 GMT400 and 2000-2007 GMT800. Lots still on the road.

Instrument cluster lights are original color. Chevrolet and GMC standard backlight is white for gauges, green for DIC (odometer). If you have a Denali or escalade, gauge backlight was a light blue and DIC odometer is still green.

I bought my 2003 z71 burb 4 years ago for $1000 with about 290,000 miles on it.2 weeks ago I just got over 400,000 miles

Wow that’s great! What have you had to replace or repair during that many miles?

@Mikey-Best wow that’s great! What have you had to replace or repair during that many miles?

​​@@doctube2020I picked up my 05 Burb Z71 in 2022 for $2,300. It had 350k+ miles on original motor, and the trans was rebuilt prior to my purchase. I've done regular maintenance, changed one wheel hub and new tires. Will get new engine in future. Torn on 5.3L or 6.0, I'm seeing people say the 6.0 has too much torque for the factory trans. Idk, when it was rebuilt if they upgraded it or not, my guess would be probably not. So if I baby it and don't drive like a dummy, the trans may last with the stronger 6.0. I do plan on doing long distance towing with the vehicle and it did come with trailer brake installed already . Now it's still

Quieted certain resonance in rpm range down a lot. Still sounds like a proper v8 but more civilized I’ll have to do a driving video

@@doctube2020 Thank you.

New video will be available in an hour.

They are very reliable engines, especially the non AFM / cylinder deactivation years 99-2005. I think they started using AFM in half ton truck and suv 2006+ maybe 2005+

@@doctube2020 AFM started in 2007 on the 5.3 engine. It started in 2010 on the 4.8 engine.

And Dayum at 2k rpm you average about 30mpg that’s kinda good for a heavy truck

Ha the instant economy is fun to watch. I’ve averaged 18 - 20mpg if you drive 60- 65 on 2 lane flat roads. But as soon as you hit a hill or go faster than 70 mpg drops.

Was this the traditional tune? Or did you send in data?

@monkeywrench3046 Traditional tune where you send in the ECM.

@monkeywrench3046 Traditional tune where you send in your ECM. Supposedly you can get a hotter tune and it’s customized to your vehicle with the auto cal scan cable tune but that’s a lot more $$$. I’m happy with the traditional tune

Thanks! It’s a looks nearly mint 15 ft away or driving by lol

Yep, 2004 and up had the ethanol sensor, different fuel pump, fuel lines and injectors. Engine is the same internally.

dzięki

Thanks! I wasn’t looking for a suburban but a good friend was selling it cheap. Needed a lot of small stuff to get it road trip ready but now I’d trust it coast to coast. I linked part 1 in the description. Also have some other videos like 0-60 and exhaust on my channel.

I agree brother like they said like a rock

Thanks ✌️

Thanks for watching! I’m guessing any large American suv or truck aren’t very common in Italy?

Ouch!

That was purchased about 20 years ago from JC Whitney or LMC truck. Word of caution, be sure to remove it every few Months as they slowly collect dirt which holds water which leads to the front of the hood rusting out. Maybe they’ve improved them to just stick on and not bolt underneath the hood.

Thank you, I have since found one in excellent condition. I was at a friend's house and a relative of his stopped by and we were just chatting, told him what I had and was looking for he said "I believe I have that piece at home", I about fell over, we drove yo his house and sure enough. Thank you for getting back with me. Tim

@@timjohn2810 Nice! They were popular years ago to cover up rock chip damage or just to add that unique look