How To | 2009 + Present | Dodge RAM | Tie Rod Ends |
Вставка
- Опубліковано 22 лют 2022
- Vehicle In This Video: 2014 Dodge Ram 1500
5.7L ( GAS) (2WD)
The inner tie rod has a ball joint that can wear over time, causing a clunking noise, loose steering, and eventually, other problems with the wheel and suspension components. It’s a good idea to replace your inner tie rods as soon as you notice any of these symptoms. This video shows you how to replace the inner tie rod.
Support Us On PATREON: bit.ly/3qQsO07
Support Us On PAYPAL: bit.ly/3r4DPdJ
--------------------------------------TOOLS I OWN--------------------------------------
30 Degree Push Pin Removal Pliers: amzn.to/3BlCx1K
Wheel Stud Installer amzn.to/2TQkstm
Stretch Belt Tool amzn.to/3e8bYVk
Gear Wrench 1/2 Socket Set amzn.to/3e6XDIv
Disposable Gloves amzn.to/3e3Bc6Y
Toyota/Lexus Oil Filter Tool amzn.to/3k6wuti
Vacuum Brake Fluid Bleeder amzn.to/3xzATZB
Gearwrench Ratcheting amzn.to/2Vm2kHU
7-Piece Spare Tire Retrieval Tool Kit amzn.to/2VlKWmE
Oil Filter Wrench Wrench Kit amzn.to/3ARUjLi
Oil Filter Pliers amzn.to/3yENJpo
Craftsman 1/2 Impact Sockets Set amzn.to/3e5z92e
Screw Driver Set amzn.to/3hYt5K5
Hand Impact Driver Set amzn.to/3yFdF48
Dual Piston Brake Caliper Push Tool amzn.to/3yJDe47
Wind Back Brake Caliper Tool Set amzn.to/3yKGlsJ
--------------------------------------------------------------------------------------------------------
If this video helped, let us know in the comments, and if you liked this tutorial, leave a like and subscribe fore more content like this! Thanks for watching!
Repair Tips & Secrets Only Mechanics Know
DISCLAIMER: This video description contains affiliate links, which means that if you click on one of the product links, I’ll receive a small commission.
#howto #diy #DodgeRam - Авто та транспорт
Put alittle lock tight on the treadths
Great instructional video minus you left of the very important torque spec for the tie rod end. 55 ft pounds plus 90 degrees
What do you mean? I gotta change mine so I wanna do it right ?? Also if just the outer is bad should I do both or the inner as well?
@@lawrence279 I just replaced both tie rods inner and outer since they were relatively inexpensive and only takes about 20 minutes each. The nut that fastens the tie rod to your hub assembly you tighten to 55 ft lbs torque and then 1/4 turn
whats the torguw spec for the tie rod
55 ft lbs plus 90 degrees
How come you tried taking it off with that plier first and then went to special tool ? Wasn’t coming off ? Getting as much info as i can before doing it myself..
At 4:28 and 4:39 actually that’s the best tool use for this job
@@AutomotiveDysfunction i did buy some kind of clumps to torque it with a gun but i have a big ass pipe wrench and i hope that will do the job..
@@Italianborn it will do actually trucks are very easy to do as you can see, you don't even need special tool just big size regular wrench or adjustable wrench..might have turn steering wheel fully to left or right just to make it even easier ...