Відео

I have got a boxer crush elrs, is there any video to setup it up in beta flight?

oh I know that skatepark. Love your videos man your GPS rescue video has come in handy!!

Hello Dshot, Are you interested in reviewing our brand FPV products? Thank you!

Would you know why when I go to arm my drone un plugged from laptop and battery connected all the drone does is beep.

pls make a build vid for this.

Where can i find those wires you used for the reciever?

I have just finished binding everything (using DJI FPV controller and Goggles Integra and when I arm the drone and start to apply the throttle, the motors spin at a certain speed and I can't increase or decrease the speed it's like it get stuck. The throttle only goes about 20 - 25% then gets stuck. I am trying this without the props on and on the floor, in angle mode just to make sure they work.

thread the straps through the slot

What gps are you using?

Can i use ELRS with this, Like my radiomaster pocket

Sorry to ask more questions but i cant find this frame anywhere other than rotoriot and they are charging 100 dollar shipping to australia. Would the DJI camera work in your speedybee build? or can i get this frame cheaper somewhere?

What props should I buy? Thanks for the great vid btw

Could I run this on 4s?

I’ve got a couple questions. Does pre powering the gps on the tailgate set that point as home? Or does it set home point at take off point when you’re over on the grass where you plug in the Lipo and arm? Thanks

My GPS has saved me more than a few times now, but has failed at least once. Can’t wait to change my settings to yours. You pack a ton of info into your vids. Your style of explanation helps make BF easier to understand, thanks. I’m always excited to jump back into BF and change up some settings after watching your vids! I just installed a gps mate on my 7” build to power the gps unit for a cold start. Do you ever shield and ground your gps wires ? Thanks again, great content !

Whats te differants betweenthe geprc f722 35a aio and the geprc f722 35a aio v2

GPS has saved me least five or six times. Do the signal interruptions. The receiver should always come back to the radio that's basically what it's doing? Once I build her buy a drone I just set it in one direction and go full throttle and forget about it. 😂 If the Earth is round and not flat it should come back right?

rpm filtering is this needed?

do you need failsafe stage 1 or can you do just stage 2. I am using the DJI FPV controller and have stage 2 set to the default RTH button on the controller. Can I set failsafe stage 1 and 2 on the same button (RTH button), as I done have many buttons with this controller and wanted to do the two all on one button. Sorry if its a weird question, as I havent flown my drone yet and wanted to make sure I done it correctly.

good job men!

Great vid ! Killer info … well explained. At about 48:00 , done with motors tab, you said disconnect from BF and fire up with battery and radio. Tried it , but it wouldn’t arm the motors to check them. Green light on TBS rx and bound. Any ideas? Thanks.

Good Job! I learned a bunch about the mysterious GPS. This is perfect and timely for me. I will use this to set my GPS on my quad. Might have to call you Barwell Jr. LOL

If I set a fixed altitude, does it rise by the meters I set (for example 50) from the point where I am at that moment or from the altitude when I took off?

THE BEST EXPLAINS !!! THANKS

Buenas puedes recomendarme alguna powebank para alimentar a la controladora para cargar los GPS antes de colocar la batería ? Gracias.

Awesome video I couldn't get gps rescue working before watching this so thank you I have one question when my gps rescue is initiated the drone flys great for a few seconds then it gets this rocking on the pitch axis for a couple seconds then it flys great again it does this all the way back ?Any suggestions or is this normal

Great, absolutely no indication of which way the props go? Bravo

I have been buying PNP for a year now; I just built my own, and this was a lifesaver video. I know i will use it again. Thank you so much. Great job; it is excellent for us beginners. I didn't feel i needed to know what every box or drop-down does!

does it fit the moonlight kit with no tweaks?

Would it be possible to make a 3 inch 3S toothpick analog drone with a 2500 mW VTX?

Very comprehensive for me, thanks

Yo I need help ppl, my board won't flash the firmware but it did upload it.

I am not really a knower... so when I hear that you said barometer and magnetometer are only important for INAV... my understanding is that you meant that this is only for fixed wing. So I quickly asked AI and it says it is not true. Both are still very useful for drones (that are using Betaflight) for more precision. Any comment? Because while researching which GPS to buy, I stumbled upon these 2. Some have some not. So now I am unsure if it is something that I should look for or ignore. I tend to believe people with experience more then AI, but still...

They recommended an overkill on the motors. ....

Subs😊

Hola amigo excelente video , al fin un rth perfecto. Te puedo hacer una consulta, con una batería lipo no tubé ningún problema, pero puse una de iones de litio y no volvió , será por la tasa de descarga ? no aguanta la acceleracion? Alguna idea eso es lo que se me ocurre, saludos

Excelente información amigo y muy bien explicado se agradece

gep rc f7 35a aio is not 25x25 its 35x35. also you missed 4 m2x8 screws on the arm install

This was helpful. Thank you. Please do the same for INAV and ArduPilot

Module settings for CRSF/ELRS in the radio would’ve completed this. Nice guide otherwise

Great job on this one.

Your soldering is sucks. That negative joint is unacceptable. You shouldn't be doing a build video, there is so many things wrong with this build is crazy. Who tf puts nuts on bolts then into motors just because you dont have 14mm loong ones?! 😂

Bro!!!! Appreciate you so much!!! Thank you! For sure got a sub from me

This is great !! thank you sir

Clean tutorial! 🎉🎉 🚀

Dope A/F Dude! Ripping bowl n pitcher

Awesome vid! I've broke a lot of drones in those trees. Surron?

If someone wants to give you some financial support, how would they do that? I'm learning from you and enjoying your channel. So, adding remote ID, GPS, external Buzzer, and strobe light seems like a lot of weight. The 03 video is good enough for me; imagine adding a GO-So, remote ID, GPS, external Buzzer, and strobe light seems like a lot of weight. The 03 video is good enough for me; imagine adding a GO-PRO. Would you increase the size of your motors or props to correct for weight? I still have many 4S batteries so that they will stay with 4S. I have been flying for six months, so I'm unsure I can handle 6S. What are your thoughts if you have time? PRO. Would you increase the size of your motors or props to correct for weight? I still have many 4S batteries so that they will stay with 4S. I have been flying for six months, so I'm unsure I can handle 6S. What are your thoughts if you have time?

My dear you know you fly fpv right you got 5 minutes to 8 minutes time fly ,you can kiss bey bey your drone,gps not gonna help you ,no battery 😂😂😂😂

Hai bro i am from india..I am see your video .. your the best teacher