Replacing My Drive shaft (VWT4)
Вставка
- Опубліковано 26 сер 2024
- I managed to replace my drivers side driveshaft and theres are the tools I used
13mm socket
17mm socket
21mm socket
24mm socket
27mm socket
21mm spanner
Breaker bar
10 allan key
M12 muti spine
Ratchet
Ratchet extensions
Hammer
My Instagram
...
Thanks for making this. Very clear explanation and images. The most comprehensive video I've seen on replacing the VW T4 drive shaft.
Your more than welcome I'm pleased It was helpful
Really well done, it's going to be very helpful to repair my year 2000 2.5 tdi T4. Cheers mate, you did an amazing job !!
I'm pleased it was helpful i hope u manage to get the job done. I pleased I could help 🤙
Great help, thank you. Found the 'tools used' bit at the beginning a great help. Surprisingly hard to find online a list of tools needed to do a job.
Mate watched this video last Saturday and it really helped me sort my inner boot out.
Glad it was helpful
Well done. Like your videos, and the old T4.
Cheers thanks for this!!👍😀🤘😎
No problem
See the one I'm fighting has the pump on the back of the block
Seriously been giving me a mental breakdown 😂😂
Great video. Im about too change my inner cv boot on My T4. Your video is spot on. I think this will help me alot.
Love too watch your videos. Thanx for recording this 👍
Your welcome mate pleased it's helped 👍
Nice one Thanks, i have done it a couple of times but this is way quicker.
Great! wish you the best
Nice ball joint tip. And good vid
Thank you
Great video for all diyers, very helpful 👍
Glad I could be helpful 👍
Great work as always. I've sourced oem replacement CV axles and in looking up the torque spec on the big outter bolt and the 6 smaller inner bolts I saw a note to always use new bolts. have you had any issues reusing the same bolts here? cheers!
That was bang on. Thanks 👏
Should have undone the 27mm bolt first with the van on the floor. Much easier and safer.
Yer I realised that after but was to late so I had to roll with the punches lol
Great video buddy 👍👍👍
Thank mate means alot 🤙
nice work homie! thx for the video, going to do my P/S DS this week!
Hope it's been helpful. Good luck and enjoy
Good job. Not sure what wood you're looking at getting but have you checked out Evo Motion Design in Wareham!
Excellent video! 👍
enjoyed the video...big thumbs up
Attaching the bottom ball joint is a bloody nightmare!
I've heard it's a pain
How long would you say this took you need to get mine done, great job well done by the way
About 3 hours but I was filming and taking my time but I would say hours and a half all in
@@PranceProject I've been looking on ebay there £58 new not to bad, are they the same both sides as they don't say left or right
There side specific mate