Brass float,oe from the factory,the plastic floats are much better,its needn a clean and new parts npieces,my dad modified the brass tubes a little bigger holes,which meant better performence on all the pieces,esp at w.o.t.ohh the power valve is shot ita a mess good luck
I had a 1971 2100 rebuilt. When I installed it I found out where the fuel filter goes in is stipped. Is that a pipe thread or do you have any ideas how to repair. Thanks
great video thank you
Thank you!
thanks. burned my brain for 2 hours before i watched this.. forgot to clip back the float. kept flooding the carb. 😅
Glad it could help!!
Thank you. This helped a lot - plus, nice job!
Aweosme!! Glad it helped!
Forget the small 2 hole choke assembly gasket?
do you need to plug the hole in the front center of the carb top? mine was spraying out fuel so plugged it with red RTV.
Hmm. Haven’t had issues yet.
The one I was working on was doing the same. I’m gonna rebuild the carb and will let you know
Put it all together and it runs
Brass float,oe from the factory,the plastic floats are much better,its needn a clean and new parts npieces,my dad modified the brass tubes a little bigger holes,which meant better performence on all the pieces,esp at w.o.t.ohh the power valve is shot ita a mess good luck
I had a 1971 2100 rebuilt. When I installed it I found out where the fuel filter goes in is stipped. Is that a pipe thread or do you have any ideas how to repair. Thanks
I’m not sure. Mine was threaded
if i were you , id JB weld a threaded fitting in and use a nipple and an inline filter. once its cured JB is impervious to gasoline
What kind of fuel filter is that, the one you unscrewed off the carburetor? Part # and where? Thanks.
@@markfeuerherdt2338 wix 33046. On Amazon.
Thanks!
how much shaft play is too much and will cause a vacum leak?
his sounds pretty tight and squeaky
I’m not sure.
gaskets for the jets?
He put them on in the video
@@288gto7 i was asking cause i have never used gaskets for the jets.
need to tune it still