D16Y8 Head Swap On D16Y7 Block
Вставка
- Опубліковано 6 гру 2020
- Swapping the D16Y8 head over to the Y7 block.
Also, new knock sensor installation and starting to get the engine back together.
Related videos for this job:
B16 Head Removal
• Honda D16 SOHC Head Re...
Water Pump/ Timing Belt:
• Honda D16 SOHC Timing ...
Valve Cover Removal:
• Honda D16 SOHC Valve C...
Distributor:
• Honda D16 Distributor ...
As always, thanks for being here :)
Due to factors beyond the control of me, the video owner, I cannot guarantee against unauthorized modifications of this information, or improper use of this information. I, the video owner, assume no liability for property damage or injury incurred as a result of any of the information contained in this video. The video owner recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of the video owner, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not the video owner.
This is a video of me doing work for myself. This video is not meant to be a how-to instructable for viewers. - Авто та транспорт
What tools needed to do this? And did you clean the parts before installing?
What all is needed to do this. Ecu manifold head and wire up vtec ? Y7 dizzy work along with y7 head bolt work ?
Did you find out if you need the y8 dizzy???
What y8 head code you use on that block? I have a p2j1 Esrly version any advice ?
What is the compression ratio?
Great video, I'm planning on this same swap.. Is there anything else that needs to be done aside from replacing the head? will I need to do anything with the ECM ?or is it plug and play?
Just the head, coolant tube/thermostat housing on back of engine, and the knock sensor. Easy peasy. I also swapped the stamped oil pan for the aluminum one just because I prefer it that way
Gotta have the vtec ecu or it wontwork
@@strickracing437 which ecu should you get?
@@jeff666p ecu out of a ex model
@@strickracing437 thank you
What did u clean the head surface with? It was clean as a whistle
He probably used a drill wiring tool to clean off the old dust and dirt
I have a Y7 block with a Y8 head but I don't know how to time it
ua-cam.com/video/Xt2CavOgcac/v-deo.html
@@cuptain85 thanks bro