Hi. I’m replacing the switch for my boat and correct me if I’m wrong. Was the wiring as follow? 1. Red 2. Black 3. purple 4. Yellow and black stripe 5. Yellow and red stripe 6. Black and yellow stripe. Thanks. Great video
PinPoint Fishing With David Standridge 9:42 AM (1 minute ago) Hello Robert, 1: Yellow/Red= Start Solenoid 2: Black = Ground 3: Yellow / Black = Choke 4: Red = +12V 5: Purple = Ignition 6: Black / yellow = Magneto (Is ground when in the off mode) Hope this gets you back on the water! Thanks David
@@jameschess6651 Hello James, Have you got this resolved yet. if not reach out to me . pinpointfishing.djs68@gmail.com will be the best way to contact me. Thanks I don't trust the You Tube notifications
Great video, and great ideas with the quick connect and carrying a spare on board, thank you!
Thank you!
Thanks for making this helpful video. I just subscribed.
Thank You Jim for your feed back and subscribing.
Thank you for your time, and doing this video, very much help full. I did subscribe to your channel. 😊
Awesome, thank you!
Yes I had a bad wirer it was broke I replaced it and it work fine thanks a lot
Good deal! Tight lines!
BTW, switch comes with 2 ground jumpers and 2 purple jumpers on splice ends, most models…
Hi. I’m replacing the switch for my boat and correct me if I’m wrong. Was the wiring as follow?
1. Red
2. Black
3. purple
4. Yellow and black stripe
5. Yellow and red stripe
6. Black and yellow stripe.
Thanks. Great video
PinPoint Fishing With David Standridge
9:42 AM (1 minute ago)
Hello Robert,
1: Yellow/Red= Start Solenoid
2: Black = Ground
3: Yellow / Black = Choke
4: Red = +12V
5: Purple = Ignition
6: Black / yellow = Magneto (Is ground when in the off mode)
Hope this gets you back on the water!
Thanks
David
I just replaced the switch just like the one you replace switch come on but no fire to the engine
@@jameschess6651 Hello James, Have you got this resolved yet. if not reach out to me . pinpointfishing.djs68@gmail.com
will be the best way to contact me. Thanks I don't trust the You Tube notifications
Would you know if the bus bars are behind the dashboard
Called 6 wire Mercury Ignition Switch…
Hey Dave could you post those wire color diags or tell me where I can get them? Thx.
Email me at Pinpointfishing.djs68@gmail.com and i can send you the pictures of the wiring code
Thanks
David
I plugged one of those in and engine still doesn’t start?
Check your kill switch. It may need to be replaced. Good luck!
Would this be the dame switch for my 2013 Mercury 60hp four stroke
Can you take a picture of the connection (plug-in )
We can see if it is the same or not.
Wer you faint Seth control?
What gauge of wire is that
I believe it is14AWG no smaller than 16AWG