Fabricate fuel lines | How to make your own gas lines quick and easy | replace leaking gas lines
Вставка
- Опубліковано 11 чер 2020
- How to video. Fabricate fuel lines | How to make your own gas lines quick and easy | #replace #leaking gas lines. Cheap to make your own #FuelLine
My Amazon store for featured tools & products: www.amazon.com/shop/carlsgarage
My website for merch/tools/products/contact/socials: direct.me/carlsgarage
Disclaimer:
Due to factors beyond the control of FerKurl, I cannot guarantee against improper use or unauthorized modifications of this information. FerKurl assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. FerKurl recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of FerKurl, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not FerKurl. - Авто та транспорт
Thanks for the info. Very educational.
Thank you for this tutorial
Man U just solve my problem thanks man
Nice video fer!!!👍🏼
very good I didn't know anybody did that anymore but I do
Nice Job!
Guess what I found in the storage cabinet? PB Blaster! Left over from years ago when You told me how much you liked it & how well it works. Probably liked JBWeld, too.
Supper help full thank you
Sec nice vid too
Wow Nice Video Man!
I’m replacing the fuel line on my 1999 Buick park avenue and my fuel filter is right in the area I need to replace. It’s a screw on fuel filter on one side so I was wondering if you have any advice on anything I could attach to the new line so I can screw the filter in
That 🇨🇦 salt got mines looking like that ..🙏💯
Feel ya bro
Can you not use rubber line for evap lines? Idk does it carry much pressure?
First
Mine broke off where the fuel filter nut is on a Chevy astro van...I will have to get new inlets that go into the fuel filter. Any help on where to do so would be amazing.
I know auto value stores typically stock a wide range of fuel unions and fittings
But I replaced it today with a rubber ones 🙏🏼
Do compression fittings need the little insert for nylon lines like they do for plastic water lines?
Posting a video on that for you now. How to use em
@@FerKurl Thanks!
Im screwed i need that jack u have to get my car above my head
What size fuel line bro????
Fun fact, the British call the Farrell
An olive
How does the plastic connect in the compression fitting??
Plastic fuel line?
Hiw safe is it to use on fuel line will it ever come loose or slip s
These are the same fittings that come with GM/Ford/Chrysler fuel line repair kits. If installed properly they won’t come loose
Any opposition to using soft fuel line? My thought… one it’s easier two it doesn’t need to be hard line because it’s not a lot of pressure and it won’t rust.
i was wondering the same thing... put a new carb in my snowblower but the angle of the fitting was slightly off and theres no extra slack to get it on all the way. I was looking to use this as an extension to add more line instead of replacing the whole line.
I did it on my suburban years ago and have no issues
Why the heck would you not change it to nylon? No more rust!
Did ya need a flaring tool?
That is a compression fitting in the video so no flaring need but you can go the flaring route and use unions and fittings