Honda XL carburetor rebuild and test ride

Поділитися
Вставка
  • Опубліковано 21 тра 2022
  • Finally got around to getting a Keyster rebuild kit for my 1977 XL125 to cure the carburetor woes and improve reliability.
  • Авто та транспорт

КОМЕНТАРІ • 20

  • @julienlalondemymachines
    @julienlalondemymachines 6 місяців тому

    Great video I needed help rebuilding mine 🙏

    • @Garage2Trail
      @Garage2Trail  6 місяців тому

      Thanks! Glad I was able to help!

  • @jeschreindl
    @jeschreindl 2 роки тому

    That is such a sweet little bike, seems to be a solid runner too

    • @Garage2Trail
      @Garage2Trail  2 роки тому

      Thanks! Yeah it’s a nice little runner. This rebuild kit helped it even more.

  • @toddbachman3912
    @toddbachman3912 7 місяців тому

    77 I HAD ONE LIKE THAT👍👍👍

  • @thomasdausch8557
    @thomasdausch8557 2 роки тому

    Nice older Honda, good job,

  • @diegomuuo929
    @diegomuuo929 10 місяців тому

    I have a little Honda XL200, the problem with my carb is that the bike wont start or run with the choke off you have to keep the choke open at all times for it run, what could be the problem? any help is much appreciated

    • @Garage2Trail
      @Garage2Trail  10 місяців тому +1

      That sounds like the slow jet also called the pilot jet. That’s usually the culprit for having to run with the choke on. Some of those are pressed into the carb and the best way to clean them is with a small bit of wire to run through and compressed air. If it’s the screws in kind you can remove it and run wire through that too. Make sure all the other small passages are clean for the idle air circuit. The pilot jet was completely blocked on that 125 in the video when I got it. Hope that helps!

  • @gregoryknight6932
    @gregoryknight6932 Рік тому

    Where do you find mufflers at?

    • @Garage2Trail
      @Garage2Trail  Рік тому +1

      Swap meets are probably the best place. Vintage Days at mid Ohio would be the ideal spot

  • @jonny6758
    @jonny6758 Рік тому

    Thinking about getting one of these can you find parts or easy to work on these?

    • @Garage2Trail
      @Garage2Trail  Рік тому +1

      Yup the only parts that are hard to find on this bike are the side panels and decals lol. Very easy to work on too.

    • @jonny6758
      @jonny6758 Рік тому

      @@Garage2Trail cool look like a fun commuter or back road bike to grocery store getter

    • @Garage2Trail
      @Garage2Trail  Рік тому +1

      Would be great for back roads and basic trails. Not very fast so I’d stay off the main ones but still a great little bike.

    • @jonny6758
      @jonny6758 Рік тому

      @@Garage2Trail ok thank you will it cruise around 45 you'd say

    • @Garage2Trail
      @Garage2Trail  Рік тому +1

      It probably would with the right gearing but may be screaming it a bit much