How To Replace Sonata Sway Bar Bushings
Вставка
- Опубліковано 28 бер 2023
- Please support the channel by becoming a Patreon / bigwillcarcare
Disclaimer
This video is for reference only always refer to manufacturer instructions, advice and proper service manual for actual directions specifications and safe practices when working with tools and equipment. Due to uncontrollable factors Big Will's Car Care is NOT Liable for any misuse or improper usage of Products, Information, Mechanical Equipment, Electrical Equipment, Hand Tools,Power Tools, Ramps, Jacks, Jack Stands, Cleaners, Grease, property damage, injuries, loss or damage that may result from any inappropriate and or improper use of this video and tools
Great job ...much needed
Thanks for watching please Like, Share and Subscribe if you haven't already
I have nothing but gratitude for you. THANK YOU!
You're very welcome! Thanks for watching please Like, Share and Subscribe if you haven't already
I own a 2007 Sonata and I have been terrified about getting to my sway bar bushings, and you just made it look so easy. Fears are gone and I know I can do it now lol
Glad it helped. Thanks for watching please Like, Share and Subscribe if you haven't already
I just changed the bushings on a 2006 and after spending and over 2 hours getting the bolts out in the tight space from below, I realized is could use about 24” of 3/8 extensions and reach straight down front the top by the firewall to the bolts. If I would started knowing this it probably would have taken about less than an hour total to do them.
V6 or 4 cylinder? Should be the same but with the bigger engine just wondering if there's still enough room to do it from the top.
@@kevinftw16 It was the 3.3 V6
@@stevephilibert Cool so I should be able to get it from the top then
Well...Got my azz kicked today by those sway bar bushings!
Thanks for the vid
Hello from Florida USA.
Can you tell me those cheaper links and bushings on Amazon and ebay are any good?
Thanks for any answers!
My 2005 Optima is a bear to do these. The front 14mm bolt is slightly under inner tie rod boot. Any suggestions?
In that case you have to disconnect the outer tie rod from the knuckle and move it out the way enough to get to the bolt. Thanks for watching please Like, Share and Subscribe if you haven't already
Will this be the same method for the previous generation Sonata (2006-2010)?
Yes it's is similar. Thanks for watching please Like, Share and Subscribe if you haven't already
It’s not easier, but I’m replacing mine while I’m replacing the turbo. The entire subframe has to come out, and that makes it “easy” to get to, but getting the subframe out is a chore. Going to go ahead and replace the lower arms, tie rods, sway bar links, and the steering rack. I’m at 140k miles, I have it torn apart and to the point I can get to all of it, rather do it now than have it fail in the next 5 years and be doing it again.
@rrsttt7505 Thanks for watching please Like, Share and Subscribe if you haven't already