2011-2018 Mercedes CLS550 - Replace Front Brake Pads, Rotors, & Pad Wear Sensor - Girlie Garage

You wear sensor should tell you when it's time to change your brake pads. See below for tools and torque specs.
TOOLS USED:
18mm socket and ratchet
8mm socket
T30 torx
Small pry bar
1/2" drive torque wrench
Punch & Hammer
TORQUE SPECS:
8mm bolt 5-7ft-lbs
T30 5-7ft-lbs
18mm bolts 85ft-lbs
Courses Available from Girlie Garage:
"How to Save $$ At The Mechanic" : courses.girliegarage.com/
Patreon: patreon.com/GirlieGarage
Website: www.girliegarage.com
Facebook: / girlie-garage1
Instagram: @GirlieGarage
TikTok: @GirlieGarage
Song Credit:
Night Out by LiQWYD / liqwyd Creative Commons - Attribution 3.0 Unported - CC BY 3.0 creativecommons.org/licenses/b... Music promoted by Audio Library • Night Out - LiQWYD (No...
Chapters:
0:00 Introduction
1:06 Removing pins
2:00 Remove set screw
2:05 Remove brake pad wear sensor
2:20 Spread pads
3:50 Remove caliper bracket bolts
5:01 Remove & replace rotor
5:55 Install caliper bracket bolts
7:22 Install brake pads
7:46 Install hardware
8:43 Install brake pad wear sensor
Due to factors beyond the control of Girlie Garage, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Girlie Garage assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Girlie Garage recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of Girlie Garage, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not Girlie Garage.