Vacuum repairman shows how to fix your broken dyson V7, V8, or V10 dirt cup!

Поділитися
Вставка
  • Опубліковано 18 гру 2022
  • Tips on how to repair your broken dyson
    Interested in investing in a quality vacuum that can last you 20 years? Contact us directly at (321)454-3838 Ask for Brett
    www.richardsvacuum.com

КОМЕНТАРІ • 13

  • @photoartistry5744
    @photoartistry5744 3 місяці тому

    Perfect fix. It just needed a little squeeze. Thank you!

  • @CarolynMeade-tj1qz
    @CarolynMeade-tj1qz Місяць тому

    Thank you! Video explains this fix so well!

  • @malibuhanson
    @malibuhanson 4 місяці тому

    Thank you do much. Why didn’t i think to swueeze!

  • @milec6799
    @milec6799 Рік тому

    Thank you! It was helpful 👍🏼

  • @rolliebca
    @rolliebca Рік тому

    Thanks for sharing! Best wishes.

  • @ivaerak
    @ivaerak 2 місяці тому +1

    Hello I need to ask how to disassemble the dust bin completely? I made a mistake and soaked the whole bin in the water, not understanding that it contains wiring inside the pastic (!), and now I see water/dampness condensating around the wiring, inside the plastic, right between the wall of the bin and the darkgrey duct jack that sticks out. Is it possible to dettach this darkgrey duct part from the bin? I unscrewed both the tx8 screws that were visible on the bin part (one is in the red gasket area, and the other is in the grey duct part, right next to the red 'flapping door'. I have the same question about the orange pole as well, I also showered it with water, and only later understood it contains wiring inside (!). Is it possible to disassemble the pole as well, so I can be sure to dry the wiring completely?

    • @richardsvacuumcenter
      @richardsvacuumcenter  2 місяці тому +1

      There are clips holding the grey section to the clear bin. I have not been successful at separating that section. I wouldn’t worry too much about the moisture in there. It may not matter too much as that section is not open to any airflow which means the motor will not suck in any of that moisture. As far as the pole, just set it out in the sun and you will be ok as long as you don’t see any standing water in or around the plug sections.

    • @ivaerak
      @ivaerak 2 місяці тому

      @@richardsvacuumcenter Thank you! Other resources also confirmed that it is best not to pry these parts open, they (the clips) are designed to break if pried open. Regarding the water condesation, I was afraid of short circuit situation around wiring. I left all parts dry for more than 72 hours plus blowed warm air from hair dryer, assembled it back and all is well! Thanks once again for replying. Best regards,

  • @maureenmccann3715
    @maureenmccann3715 5 місяців тому

    Can i ask you how to fix my dyson when purple dots are flashing ? I have cleaned one filter and it has been charged when i try to use it. It is hardly been used. Thank you so much.

  • @mznickyr4141
    @mznickyr4141 Рік тому

    Can you purchase replacement lids?