Installing a Webasto Heater (with Smart Temp Controller) in a Promaster Van
Вставка
- Опубліковано 8 чер 2023
- Installing the Webasto Heater with Smart Temp Controller: Part 42 - RAM Promaster 2500 Van Conversion
Hey All. Welcome to the next episode in our van build series. Today we are installing the Webasto Heater along with the Bluetooth enabled Smart Temp Controller. This had been a pretty daunting project for us…..lots of parts….and lots of mystery. But it ended up going really well. The heater is now installed and pumping lots of warm air…..and the Bluetooth capability works great.
Follow along and you’ll see each step that we took to get this little project done.
If you have any questions, please feel free to leave a comment below, and please give a thumbs-up if you enjoyed this video and found in helpful to you. Subscribe to our channel to follow along on our entire van build series.
Blessings to you
Marc and Tania
---------------------------------------------------
Products we reference in this episode:
Webasto Airtop 2000 STC - Gasoline Promaster / Sprinter Install Kit
www.vanlifeoutfitters.com/sto...
Astro Pneumatic Tool 1450 13” PlusNut and Extra-Long Rivet Nut Setter Tool
amzn.to/3X0Opmg
Steel Cross Nut - Pre-Bulbed ¼-20 (100 pack)
amzn.to/3PchfhE
Dewalt Soket Set ¼ inch and 3/8 inch drive, SAE/Metric 34-piece
amzn.to/3X0OXsk
Klein Tools 11063W Wire Cutter / Wire Stripper
amzn.to/43A4qBQ
As per the Amazon Operating Agreement, I am a participant in the Amazon Services LLC Associates Program. As an Amazon Associate, I earn from qualifying purchases. This is an affiliate advertising program designed to provide a means for this content to earn advertising fees and commissions by linking to Amazon.com and affiliated sites. This is at no cost to you. Thanks for your support.
Our Promaster 2500 Van Conversion Playlist:
• Van Build Series
If you like any of our videos, please consider subscribing. And click the notification bell to be alerted when we release a new video.
#vanbuild
#vanlife
#campervan
#vanconversion
#homeiswhereyouparkit
#vanlifediaries
#homeonwheels
#projectvanlife
Mark, it is usually recommended the fuel pump be mounted at a 45 degree angle so air bubbles pass through the pump. It also ensures that the pump is lubricated properly by the fuel. Nice video, Thanks
for heating efficiency especially under the bed, in the garage area, the inlet should be as far as possible from the heat outlet for not to create a microclimate. Great install tutorial. Thank you
You guys knocked it out of the park with this step-by-step. Valuable information. This is the same heater we were planning on in our pending PM. Thanks!
These videos are so helpful!
Great job… you made something that’s so involved look almost manageable.
Dude thanks so much for this detailed installation... Im about to install this unit on my 136in PM next week. Very very helpful. Btw did you re-angled the pump at 45 degrees? Also would you do something differently a year later?
It sounds pretty loud in my headphones.
Are you guys going to be at the adventure van expo iEvergreen Colorado July 7 and 8