How to Replace 2017 Land Rover Discovery Sport Rear Brakes
Вставка
- Опубліковано 26 сер 2024
- Join my channel for access to one on one question and answers in Discord
with a 27 year Master Mechanic. / @kevinsmobileautomotiv... Land Rover Discovery Sport Rear Breaks www.kevinsmobilerepair.com
Excellent video my man!
I just finished changing the brakes and sensor on my 2016 disco sport according to your vid and spot on.
Just a few notes for the next guy.
1. The bottom caliper nut is in a shitty spot, so get a low-profile hex socket or a nr.7 allan key for it. You dont really need to do the bottom nut though. The top one is enough and the caliper will be able to swing down.
2. Chock your front wheels. For heavens sake, secure them! Either go buy a wheel chock, it cheap, or use bricks. Just dont forget this.
3. Getting the car in brake service mode...
- Ignition on.
- Press e-brake down (keep holding it)
- 1 second later press accelerator down (keep holding it as well)
- 1 second later turn Ignition off and immediately back on.
- Release e-brake
- Release accelerator
You will hear the electronic brake release for about 7 seconds. You can leave the Ignition on or turn it off.
4. To take the car out of brake service mode, do the same but instead of pressing the e-brake to release, pull it to engage. You will hear the electronic brake engage again.
Good write up
👍
Great videos! My GF’s 2015 Discovery just lit up the brake light and so now I guess I’ll be learning how to do this. My first question is, I’d there any way to know if it was the front sensor or the rear sensor that caused the warning light to come on? I know I can look at the pads to see which ones are worn the most but for the purpose of knowing which sensor cable to order. TIA
no the system does not tell you its general the pads that are worn are the ones with the sensor being needed
Grab your torch and go have a look at both. You'll see the ones that are flat and close to the disc.
How do you set the maintenance brake mode on a Range Rover Velar? Thank you
need to know year and engine size see if it shows anything
Hi great video 👍🏼. Is this also the same process for a full size 2017 Land Rover discovery 3.0l v6 (Gas) engine? Thank you
Should be yes
Is it actually necessary to replace the sensor wire?
Provided the sensor pad is not worn down to the point the brake lite on inside has come on.
Where did you get the tool to compress?
www.amazon.com/Lisle-25750-Piston-Caliper-Compressor/dp/B0002SQUTU?source=ps-sl-shoppingads-lpcontext&ref_=fplfs&psc=1&smid=ATVPDKIKX0DER
How do you put in maintenance mode i could not find it in your description thanks .best video how to do the rear brakes especially without taking rear parking brake off.
with ignition switch on
Press and hold parking brake switch is release position
wait 1 second
press and hold accelerator to the floor
wait 1 second
turn ign switch off then back on
you will hear the motor retract in the back.
to take out of service mode so all the same but brake switch in the apply position
@@kevinsmobileautomotiverepair thanks so much.
Hi, excellent video but simple question on setting EPB into maintenance mode. After you hear EPB motor retract (Ign.Switch still 'ON'), do you turn Ign back off (to do the work) or leave 'ON'
@@anthonyrobins1077 yes you can turn the ign off
7:44 who has that creepy laugh 😂
That would be meeeee
*Brakes
Got to love auto correct sometimes. On PC does not do on phone all the time.