Land Rover Range Rover Sport Rear Brake Replacement w/E Brake Disable How to DIY! L494 RRS
Вставка
- Опубліковано 6 лип 2023
- Installing new Rear Rotors and Pads on my 2016 Land Rover Range Rover Sport. This is a HSE Model so it has the small brakes from the factory.
Applies for all L494 Body style range rovers. Procedure to put the E Brake in maintenance Mode is in the video.
Parts purchased from Rock auto, Power Stop Pads, Centric Rotors. - Авто та транспорт
What part of the video do you explain how to put it the brakes in service mode???
8 Minutes in i explain and show it.
Is that a 2020 Range Rover sport SE I thought the rear brakes has four calipers pistons and the front brake has six caliper pistons
It is a 2016. Only the SVR and 2017 HST received those brakes on the early L494. 2018+ received them as standard. The 2014-17 HSE/SE all trims received a standard brake caliper.
One question
Does the suspension have to be on a certain mode to jack it up?
It is recommended
its easier when in off-road mode when you need to get the wheels off, as for "jacking mode" does exist but some cars go into it, and some dont. Last time i was jacking mine up i got a good 3 feet in the wheel well, and the wheels were still on the ground
As they said above it I'd recommended to be in offroad mode but I have never done it. I just jack it up at its current height and don't go any higher than necessary
My friend, can you help me delete the message about worn brake pads. thank you
Hi, I am wondering if perhaps your sensor is faulty or is not plugged in properly or is damaged. I never had to do a reset, I installed the new sensor, plugged it in, and when i turned the truck on the light went away.
Which way does it wind in please, not sure if mine seized
Lefty loosey. But please watch more of the video I found out when I got the e brake disconnect per the trucks dash board procedure on screen it auto pushed in.
@@cpstang24 i appreciate your reply, yes I'd watched it all the way through first, I have a clockwise piston tool, still anti clockwise on the opposite side im currently trying to do, thanks again
@daveshore6213 ok got it. If not take needle nose pliers with some pressure applied push down and twist