Can you please do a step by step on how I would do all the wiring for this? I'm planning on installing a powered sub. How do I get power to it and how/where do I tap it into the sound system. Thanks
Any chance you live in Central Florida? LOL!!! Can you provide the specs for the speaker box/tray? That is an awesome set up and exactly what I'd like to do.
No, I’m not in Florida! The crude measurements I have written down are 38.75” wide, 30” deep, and 7” tall in the front and 5.25” tall in the back. I don’t know if a full size spare will fit with these measurements as I have the smaller spare. Thanks.
@@themellowmechanichello sir, how did you tune the port? Diameter of port hole and length? Whats the area of the enclosure after removing the volume for the port? Thanks!
It looks like it uses the main signal input, usually from the front speaker output of the head unit to turn on. If it’s not turning on then you might need to put it in defeat and run a remote 12volt switched signal wire. Read the owners manual on how to put it defeat. I did not used adapters to get my signals. I opened the doors and taped into where the factory speaker wires attached to the speaker.
Can you please do a step by step on how I would do all the wiring for this? I'm planning on installing a powered sub. How do I get power to it and how/where do I tap it into the sound system. Thanks
Great video, think I recognize that old sub
Any chance you live in Central Florida? LOL!!! Can you provide the specs for the speaker box/tray? That is an awesome set up and exactly what I'd like to do.
No, I’m not in Florida! The crude measurements I have written down are 38.75” wide, 30” deep, and 7” tall in the front and 5.25” tall in the back. I don’t know if a full size spare will fit with these measurements as I have the smaller spare. Thanks.
@@themellowmechanichello sir, how did you tune the port?
Diameter of port hole and length?
Whats the area of the enclosure after removing the volume for the port?
Thanks!
That sounds really good
Any guidance in replacing the tweeters? Is there any space to cram an attenuator in that tweeter well, so they aren't at the same level as the doors??
It might be tight, if you get creative there should be enough room.
Amazing video! What trim of Bronco Sport is this? (Outer banks?)
It is the Big Bend trim.
What color r the wires u got signal from for the amp? Where did u tap into them at?
I tapped the factory wires in the door panel at the speaker. The driver side is blue and grey. I’m not sure about the color of the other speakers.
Which is positive and negative? Thanks!!
Working on one of these now. Harness I got for radio to bring signal to lc7i did not work. What did you do for this?
It looks like it uses the main signal input, usually from the front speaker output of the head unit to turn on. If it’s not turning on then you might need to put it in defeat and run a remote 12volt switched signal wire. Read the owners manual on how to put it defeat. I did not used adapters to get my signals. I opened the doors and taped into where the factory speaker wires attached to the speaker.
the touch screen on my stereo stop working after they install amplifier
Where did you run the ground too
I ran it to one of the fasteners holding the rear seat belts.
What box model and brand did you pull those subs out of?
I got it out of a Pioneer Sw-8mk2.
Are you eating
Yes, I grabbed a handful of almonds before filming the last part of the video. Amateur mistake!