I use the same type of of thread carriage, I has been a bit of struggle using the spring tension only, so I go around the thread spool holders, snake like, then I make minor adjustment at the spring tensioner
Great content!!!! When you grind your guide feet to a sharp slope, without an under wrap, would the guide feet damage the blank? Can you do a video on this?
No. The bottom. Of the guide feet are flat, I grind the slope on the top then you grind the burr off the bottom. Yes I will do a video. Thanks for the idea.
@@fdxcustomrods I tried sending the email to what you posted it didn’t go through so I went to your Facebook page and tried to email address so I don’t know if you received it
Thank you for the thread tension information, the video helped a lot
You're welcome
Knowledge from the master is the key!
Thanks G
I use the same type of of thread carriage, I has been a bit of struggle using the spring tension only, so I go around the thread spool holders, snake like, then I make minor adjustment at the spring tensioner
👍
Where did you get the thread carriage? Seems nicer then the CRB hand wrapper that takes up the base and you have move the supports each wrap 🫤
That's my Alps power wrapper and carriage.
Thanks 👍
Thank you great info,keep up the good work.
You're welcome, thanks for watching
Great content!!!!
When you grind your guide feet to a sharp slope, without an under wrap, would the guide feet damage the blank? Can you do a video on this?
No. The bottom. Of the guide feet are flat, I grind the slope on the top then you grind the burr off the bottom. Yes I will do a video. Thanks for the idea.
Just wanted to let you know I did end up shooting you an email. It’s nothing you have to respond to right away.
👍
@@fdxcustomrods I tried sending the email to what you posted it didn’t go through so I went to your Facebook page and tried to email address so I don’t know if you received it