Nice video dude. I will have to do this to mines (2004) lancer es. When I’m driving you can hear the driver side wheel just banging sounds like a helicopter at high speeds. Took the tire off today and outer tie rod is shot.
I used the harbor freight inner tie rod remover, for it for 25 dollars and the investment was well worth it. You can also rent them from auto parts stores for some insanely large price.
There’s a little metal ring, that locking ring that you have to put in before you put the tire rod on (new). I had to bend back the little ears back on the older one in order to remove the old tie rod. Without bending those little ears back, you’re going to spin your whole rack potentially damaging it.
Hello my Mitsubishi Lancer ES 1.6L 2002.? My Rear Inner Tire is Getting Bold. Kindly Need Advice which part may I purchase to replace ? Need Help PLEASE From Anyone, Much Appreciated... Thank You
Check the rear strut because usually with those were out there cause we are on the tire because they’re pushing the tire: if you have a camber bar check that too.
![CV Axle Replacement [2002 Mitsubishi Lancer]](http://i.ytimg.com/vi/OVUJAnngV38/mqdefault.jpg)
Nice video dude. I will have to do this to mines (2004) lancer es. When I’m driving you can hear the driver side wheel just banging sounds like a helicopter at high speeds. Took the tire off today and outer tie rod is shot.
How much force did you put when tightening de inner tie rod? Also, what were you hammering after you installed them?
What are you hitting with a hammer on the inner tie rod, thank you, I'm about. To do mine
There is a flat washer, that is bent over and access the lock to keep the inner tire rod from spinning off the rack
Thanks so much
Can you tell me what tie rod tool you used? Thumbs up for your video!
I used the harbor freight inner tie rod remover, for it for 25 dollars and the investment was well worth it. You can also rent them from auto parts stores for some insanely large price.
What were you hammering on before putting the tool on the old tie rod to remove?
There’s a little metal ring, that locking ring that you have to put in before you put the tire rod on (new). I had to bend back the little ears back on the older one in order to remove the old tie rod. Without bending those little ears back, you’re going to spin your whole rack potentially damaging it.
What is the tool you used for the inner tier rods called
It is called an inner tie rod removal tool.
Hello my Mitsubishi Lancer ES 1.6L 2002.? My Rear Inner Tire is Getting Bold. Kindly Need Advice which part may I purchase to replace ? Need Help PLEASE From Anyone, Much Appreciated...
Thank You
Check the rear strut because usually with those were out there cause we are on the tire because they’re pushing the tire: if you have a camber bar check that too.