Oh boy, even your old lights were brighter than my lights, i sure need to upgrade mine.I like the simplicity of your video. It's just a nice video and not bs. Thanks, dude.
I wish someone who does these vids would actually slowly video the light from about 2 feet away so we could see how the fit is...side to side and also looking down to see if it sticks out the same...Also the led you bought will not give you the correct light for the lenses...you need the leds that look flat on both sides and have a band of leds usually 3 to mimick the light from a halogen bulb...The 9004 bulb is a high/low bulb so there would be 6 leds on each side 2 rows of 3 offset a little bit...also they should be able to be adjusted 360' to line up properly...9 and 3 o'clock position...this will give way better pattern and not blind the oncoming traffic...brighter also...Thanks for the vid and good luck...
Just got my 2000 second gen club cab back on the road after cab corners, lower door skin on passenger side, nice junk yard drivers door and front opposite side fender and new back bumper. Went from maroon to olive green metallic. You should see her. Found your video for LED advice. Thanks
I bought OEM headlights and put LED bulbs in them. I put red led bulbs in the turn signals. Love them. Bright as hell. Did not do the fog lights. Did not do my brake lights yet. Although I did put LED bulbs in my reverse lights.
in order to fix your blinker problem you need a LED relay flasher that goes on the left side of the steering wheel when you open the door. you’ll see it in there. the fuse box will have 2 of those. one is for the blinkers and the other is for the emergency lights if i remember correctly. i changed out both of them years ago because i’m running all LEDs. actually i have a video on m channel on it if you want to exactly what i’m talking about
The LED signals need 50w 6ohm LED load resistors .. Won't the LED headlights run hot with the rubber boots restricting air to the LED bulb cooling fans ..
Headlights work great- but the tail lights- I put LED for turn signal, but the brake/ running light (while on) won’t turn on. Rotated 180° and tried again… nothing. Both sides. Any suggestions?
So I installed LED headlight bulbs and LED fog light bulbs but I can’t seem to run them at the same time. When my headlights are on and I turn the switch on for fog lights, the highlight beam comes on and fog lights won’t turn on. Only way the fog lights work is if I don’t turn on the headlamps or just turn them on half way to only light up the turn signal lights for daytime driving. Any suggestions? (1999 Dodge Ram 1500)
Oh boy, even your old lights were brighter than my lights, i sure need to upgrade mine.I like the simplicity of your video. It's just a nice video and not bs. Thanks, dude.
I wish someone who does these vids would actually slowly video the light from about 2 feet away so we could see how the fit is...side to side and also looking down to see if it sticks out the same...Also the led you bought will not give you the correct light for the lenses...you need the leds that look flat on both sides and have a band of leds usually 3 to mimick the light from a halogen bulb...The 9004 bulb is a high/low bulb so there would be 6 leds on each side 2 rows of 3 offset a little bit...also they should be able to be adjusted 360' to line up properly...9 and 3 o'clock position...this will give way better pattern and not blind the oncoming traffic...brighter also...Thanks for the vid and good luck...
That's a *sharp* looking truck my friend! 🙂👍 Nice work with the install 🔧
Appreciate it!
Just got my 2000 second gen club cab back on the road after cab corners, lower door skin on passenger side, nice junk yard drivers door and front opposite side fender and new back bumper. Went from maroon to olive green metallic. You should see her. Found your video for LED advice. Thanks
Beautiful truck , loved the lights not bad at all for the price
Appreciate it
Great video! I've been looking for a review for the rear tail lights. I like the look
Glad you liked it!
I love that truck color
Same here
I bought OEM headlights and put LED bulbs in them.
I put red led bulbs in the turn signals.
Love them. Bright as hell.
Did not do the fog lights.
Did not do my brake lights yet.
Although I did put LED bulbs in my reverse lights.
helps with driving at night!
in order to fix your blinker problem you need a LED relay flasher that goes on the left side of the steering wheel when you open the door.
you’ll see it in there. the fuse box will have 2 of those.
one is for the blinkers and the other is for the emergency lights if i remember correctly.
i changed out both of them years ago because i’m running all LEDs.
actually i have a video on m channel on it if you want to exactly what i’m talking about
fixed it
$200 to guarantee you get flipped off by every sedan you get closer than 20 ft to
Hey can u show the factory foglight switch and the harness that plugs into the foglight switch ive been tryin to figure where its located at
Reading below, no you don't need a blinker relay, its a resistor with heatsink thats wired inline at the marker light.
Relay fixed it
i can see just fine, 2 light bars do just fine :p
i bet
Did you ever get the blinker lights figured out?
nice. a lot cleaner than mine! 😃
Thanks! 👍
The LED signals need 50w 6ohm LED load resistors .. Won't the LED headlights run hot with the rubber boots restricting air to the LED bulb cooling fans ..
it was your great grandads truck???
Yep
Now that you've had them for a few months do you still like those headlights and driving lights? My 99 really needs an upgrade.
Yes, still would like brighter tho
Hey man, great looking truck. Two questions, will those products fit a 01 2500 5.9 Cummins? I believe it will.
Yes, they will
Do I need to get a resistor for these to work correctly? Same truck, bought the same lights, nothing lights up. Any advice?
Headlights work great- but the tail lights- I put LED for turn signal, but the brake/ running light (while on) won’t turn on. Rotated 180° and tried again… nothing. Both sides.
Any suggestions?
So I installed LED headlight bulbs and LED fog light bulbs but I can’t seem to run them at the same time. When my headlights are on and I turn the switch on for fog lights, the highlight beam comes on and fog lights won’t turn on. Only way the fog lights work is if I don’t turn on the headlamps or just turn them on half way to only light up the turn signal lights for daytime driving. Any suggestions? (1999 Dodge Ram 1500)
What camera do you use? super crisp footage
this was just my phone...
My trucks the same color! Hey where’d you get that visor?
Don’t see to many of them this color. The visor came on the truck
Believe you can find them on eBay
I got a 02 2500 5.9 magnum, you had any problems with your transmission lol?
Not yet
You need that little box for the front also.
What little box?
Ohh as the tail lights has? I think for the front it’s build into the bulbs but idk honestly
@@RealSteelFabrications That'll straighten out the blinker also
Where do I buy the little thing over your windshield
My truck came with the exact same one. Through it in the dumpster maybe I should have sold it.
not for sure, came on it
How are they doing now ?
Good. The taillights plastic is pealing already though
How are the rear LED lights holding up for you? Thinking about getting some
Good, the plastic did fade in one spot
Is the 98 1500 sport the same? I can’t see nothing with my headlights
Should be
the sport has a different light...2 bulbs high and low...all others it is only one bulb...they should fit the same but different wiring...
Q: where did you get those side steps?
We’re on it already
Opl-1070 running board lights how to connect 97 dodge 1500, HELP
have not done it
Where did you get the headlights?
eBay
👌🏻👌🏻👌🏻
9007 headlights, 9004 led bulbs…… adapter of some kind?
Got em backwards..lol…. 9004 headlights, 9007 led bulbs…..?
those are 2 different bulbs...look it up...2nd gen uses 9004 bulb
9004