The faulty design is Yellow Triangle Troubles, when showing up, my clients is keep pressing the triangle button, causing the Ambulance come to the front door. it happen very often
Can someone tell me where I can download a free control panel instruction manual - there are a lot of sites that have the manual but they want a subscription
I have PC1616 and PK5500 - put 1k resistor for bell and 5.6k resistors for all the zones, but i sill cant power up the system - 1. its showing message "powering up please wait" 2. after while that it flashes warning and ready lights - only on fresh start 3. message "powering up please wait" 4. only warning light is lit 5. shows on display blank time and beeps sometimes 6. it seems that system is restarting itself and goes threw steps 3-5 If i try [*] + [anything] it does nothing or sometimes shows message "system is unavailable" If i time it right i can enter *6 (for date) or *2 (to get warning info) but can't get pass master code before it restarts again Any ideas whats wrong - initially i added bell, door sensor and motion sensor, i removed all of them and replaced with resistors but problem still exists Power supply outputs ~18,8V ac PCB outputs 13.6V DC to keypad
I have a motion sensors that constantly trips and gets a "zone fault" sometimes the issues resolves itself but moat the time i just bypass it.
The faulty design is Yellow Triangle Troubles, when showing up, my clients is keep pressing the triangle button, causing the Ambulance come to the front door. it happen very often
lol
The video did not work at showing me how to change my code. It is vital that I
Change the code.
Can someone tell me where I can download a free control panel instruction manual - there are a lot of sites that have the manual but they want a subscription
I have PC1616 and PK5500 - put 1k resistor for bell and 5.6k resistors for all the zones, but i sill cant power up the system -
1. its showing message "powering up please wait"
2. after while that it flashes warning and ready lights - only on fresh start
3. message "powering up please wait"
4. only warning light is lit
5. shows on display blank time and beeps sometimes
6. it seems that system is restarting itself and goes threw steps 3-5
If i try [*] + [anything] it does nothing or sometimes shows message "system is unavailable"
If i time it right i can enter *6 (for date) or *2 (to get warning info) but can't get pass master code before it restarts again
Any ideas whats wrong - initially i added bell, door sensor and motion sensor, i removed all of them and replaced with resistors but problem still exists
Power supply outputs ~18,8V ac
PCB outputs 13.6V DC to keypad
motion and sutter sensor
timing setting kaise kar sakte h
And yes ma’am thank was a time for
Ru