Toyota Forklift No drive, Blown SFT fuse

Toyota 7 series with no drive because of the SFT fuse blowing.
The video shows the steps to take in diagnosing the cause of the fuse blowing by using a multimeter.

[@chuckvoss9344]

Glad to see you post again. I would not have found the diodes, based on the way they are enclosed. Thanks for sharing with us.

[@rogerthomas1982]

Darn, I was guessing back-up alarm or reverse lights. Good diagnosis. I haven't seen too many solenoids shorting like that.

[@steffmcgonagle7272]

Nice logical approach

[@luismelero6198]

Wellcome back!
Nice see you again.

[@jefmagnum160]

Keep it up bro, glad you back at it with the videos

[@bobeever3925]

Hi there ive got a 1996 yale glp25tf its got very good rear drive but front drive is so week it moves about an inch on fuul throttle ive checked the solinoids and both are ok. Done oil and filter for box with no improvement. Any help or ideas would be great. Andy

[@forkliftgeek10]

Sounds like the forward clutch pack is worn

[@jefmagnum160]

I got a qs tho, i got a Komatsu Fg25t-16 that has no crank when through all the troubleshooting starter is good, key switch is good but when i found the start relay by the step i found that i am getting 12v from battery and when i do key switch i get 12v as well but don’t have a ground on the other wire to close the circuit for the 12v to go to the starter wire, do you know what that small wire will be getting it’s ground? Plz help

[@forkliftgeek10]

If it is a k21 with a hitachi controller the ground for the coil of the relay is straight to the frame. The positive is from the neutral switch.

[@emilioherrera6829]

Quick question where do you get your diagrams from

[@forkliftgeek10]

Company supplied

[@HS-fw2ed]

I can send you the catalog. What is your email?