Replacing the Front ABS Wheel Speed Sensor - Volkswagen Polo

Поділитися
Вставка
  • Опубліковано 9 січ 2025

КОМЕНТАРІ • 8

  • @TheSubpremeState
    @TheSubpremeState 2 місяці тому

    Do you need a code reset to get the abs light off?

    • @screwsnutsandbolts
      @screwsnutsandbolts  2 місяці тому +2

      Usually once the faulty sensor is replaced, the light will go off once the car has been driven a short distance

    • @TheSubpremeState
      @TheSubpremeState 2 місяці тому +1

      @@screwsnutsandbolts Thanks for the fast reply. I had three different faults showing for last few months and I wasn't in best of health and those lights were not helping. I just drove out of the garage thinking it was a bad cable or something then got a nice surprise to see a clear panel. Delighted. Was a lot of problems with van and I spent a lot of money over the summer and had no transport at all for a while but this is the last problem so I'm actually very happy for a change.

    • @screwsnutsandbolts
      @screwsnutsandbolts  2 місяці тому +1

      You're welcome, glad to hear that !

  • @papadajnia268
    @papadajnia268 4 місяці тому

    If this is disel please dont drive on empty tunk....water appears insade ...put fuel to full😊

    • @ncolamascolo5437
      @ncolamascolo5437 3 місяці тому

      🎉🎉😢😅

    • @TheSubpremeState
      @TheSubpremeState 2 місяці тому

      @@papadajnia268 have you seen the filters VW use that allow specs of dirt to get through to the injectors? I don't think water can get past the first filter . It should be bled underneath in most vehicles

  • @Francesco-pe1we
    @Francesco-pe1we 10 місяців тому

    😴 'Promosm'