pt 1 2003 PT Cruiser crank no start.

Trying to figure out why this vehicle cranks but won't start after everything I did I checked the sparkplug wires and found out 2 of them were reversed. After switching them the car started right up and ran fine.

[@michaelschweizer4772]

When my timing belt went out it had a camshaft position code. That belt is a bit of a challenge to change. I changed all the idlers and plastic covers while having it apart.

[@DonaldJunior-bf2st]

Below the starter is your crankshaft position sensor change that and see what happens

[@niklak1542]

looks like your spark plug wires are not connected properly, your 1cyl is on 2nd coil plug.

[@tfboxy75]

Did you get it running since you shot this video?

[@drivewaygarage1561]

It ended up being 2 sparkplug wires being switched. I just updated the description in my video.

[@leonardormsby6311]

Put a good plug in the spark plug wire see if it's got spark

[@lindagoss2702]

Check your oil . See if it looks like mikkshake

[@9374anthony]

Mine does the same thing I have a change, spark, plug ignition coil, crank position, sensor, camshaft position sensor, it does have fuel and the bitch won’t start

[@drivewaygarage1561]

Check your sparkplug wires, make sure they're in the right order. My number 1 and number 2 were reversed and as soon as I put them on right it started right up

[@lenardtopolski738]

It's ur neutral safety switch

[@drivewaygarage1561]

It ended up being 2 spark plug wires were reversed so it was trying to run on 2 cylinders.

[@nickgordon7292]

"Promosm" 👉