Honda Odyssey Power Steering Pump Replacement

Поділитися
Вставка
  • Опубліковано 28 сер 2024
  • 2012 Honda Odyssey 3.5 V6 and it needs the power steering pump replaced. This one was really bad as they were going through about a pint every other day. It calls for 1.5 hours of labor so plan for that if you decide to do it. You only need a few tools and this can be accomplished.
    Parts:
    Power Steering Pump: amzn.to/3ST4kCU
    Power Steering Fluid: amzn.to/486cCvy
    Patreon: patreon.com/operationoverhaul
    Filming Gear:
    Go Pro Hero 10 Kit: amzn.to/3S9kd55
    Go Pro Endurance Battery: amzn.to/3S1KXUS
    Manfrotto Camera Tripod: amzn.to/3BnmYch
    Amazon Prime 30-day Free Trial: amzn.to/3L2iPk5
    Channel Members:
    Raymond Madrid

КОМЕНТАРІ • 20

  • @Cty1011
    @Cty1011 2 місяці тому +1

    This really helped. And thank you for mentioning bleeding the fluid ahead of time... Been a while since doing things like this and I almost forgot... Saved me half a day of cleanup. One of the hardest parts was actually getting the pump out, but when I turned it 180 it helped.

    • @operationoverhaul
      @operationoverhaul  2 місяці тому

      Your welcome and I am glad the video helped. The pump is a little awkward at first.

  • @michaelm9621
    @michaelm9621 3 місяці тому +1

    I was planning on taking on this project this weekend. So thanks for putting this video up and running.

    • @operationoverhaul
      @operationoverhaul  3 місяці тому

      Your welcome and thank you for the view. If you have any questions while performing the procedure feel free to contact me.

  • @Jerhunt
    @Jerhunt 3 місяці тому +1

    I plan to do our pump next weekend, and this was helpful to prepare for it. Thanks for sharing the video. I'll have to take extra care to hold on to my10mm. 🙂

    • @operationoverhaul
      @operationoverhaul  3 місяці тому

      You are welcome anf yeah make sure not to drop it lol.

  • @fthisjob6676
    @fthisjob6676 2 місяці тому +1

    Thanks for this video! I bought a new one that had the pulley attached already. There is a piece held in w allen key nuts (x2) that sits just above the pump. If you remove this its super easy to get one in w the pulley attached. Hope this helps!

  • @tjlind86
    @tjlind86 Місяць тому +1

    Thanks! Saved me a mint

  • @JohnB-kv4gf
    @JohnB-kv4gf 5 місяців тому +4

    Thanks for posting this. Very helpful. The most important question, did you find your socket and where was it hiding?

    • @operationoverhaul
      @operationoverhaul  5 місяців тому

      Your welcome and they actually found it in their garage a few days later lol.

  • @stephenthomas2730
    @stephenthomas2730 6 місяців тому +2

    Great job on the video and the pump!

    • @operationoverhaul
      @operationoverhaul  6 місяців тому

      Thank you. I appreciate the view and glad you enjoyed it.

  • @volt6008
    @volt6008 6 днів тому +1

    Whinning noise on cold start and when turning steering wheel ? Could it be the power steering pump or the seals and o rings

    • @operationoverhaul
      @operationoverhaul  5 днів тому

      I would try the o-ring first because they are only a couple of dollars and are easy to replace. Then I would drive it to see if that helps out. I have replaced those seals a lot in hondas.

  • @boingaon
    @boingaon 4 місяці тому +1

    Should we drain out all of the power steering fluid prior to replacing the pump?

    • @operationoverhaul
      @operationoverhaul  4 місяці тому

      It will make it a little less messy if you did. You could use a syringe or a siphon pump.

  • @ahyungrocks5509
    @ahyungrocks5509 5 місяців тому +1

    If leaking, should i just replace the o-rings?

    • @operationoverhaul
      @operationoverhaul  5 місяців тому

      I would do the o-rings if it is not coming from the the front pump seal behind the pulley. They are cheap and easy to replace as well.