Blue line the one with the filter attachment... also you can buy an external filter on Dave’s discount motors it collects everything before entering your carburetor diagram filter
One line uses the fuel filter the other is a small double sided nipple, similar to the fuel filter. Silicone will eventually fail, I tried, I would say anything about the same size and is hollow. But the piece is cheap on ddmracing.com
Color doesn't matter BUT I do the supply line in the upper hole of the tank (fits the filter better) and the primes in the lower hole. On the carb the supply goes to the barbed fitting and the pump line goes to the smooth (with nipple) line on the carb.
@@Grantalonus I have done it both ways, the filter is on an angle in that hole. Should be fine, just make sure those fittings are right at that edge so it won't leak.
Wish the video would have shown the connections to the carburetor as well, but thanks for this part at least.
The one with the filter goes to the barbed fitting. Thanks
Thanks man 👍👍👍
You're welcome. I did these videos because at the time I couldn't find help. Figured it out and trying to help others. Thanks for the, like!!
thank you very much : )
Absolutely, I have worked on a lot of goped sports. Let me know if I can do another video to help. Hopefully you hit like. 😁
Sooo thanks. Which one sould be attached to the upper entrance of the carburetor?
Blue line the one with the filter attachment... also you can buy an external filter on Dave’s discount motors it collects everything before entering your carburetor diagram filter
Spray carb cleaner on tip then slip it in
I guess you could, not needed in my opinion. I have done many since this video.
Whats the fitting on the yellow line? Anything else i can use?
One line uses the fuel filter the other is a small double sided nipple, similar to the fuel filter. Silicone will eventually fail, I tried, I would say anything about the same size and is hollow. But the piece is cheap on ddmracing.com
Where does the yellow hose go? I see blue goes to upper carb.
Color doesn't matter BUT I do the supply line in the upper hole of the tank (fits the filter better) and the primes in the lower hole. On the carb the supply goes to the barbed fitting and the pump line goes to the smooth (with nipple) line on the carb.
I've got the supply line in the lower lol. Will I be ok? Gonna get some gas today. Thank you!
@@Grantalonus I have done it both ways, the filter is on an angle in that hole. Should be fine, just make sure those fittings are right at that edge so it won't leak.
What’s size is the fuel line
I only buy genuine goped fuel lines. DDM has them. Not sure of the exact size. Hardware stores lines are not the right size.