That exact same thing happened to my axle threads on both sides. All I wanted to do was replace the lower control arm and had to replace the axles as well.
Dude, you have to fully unseat the indent that locks the axel nut in place. Not doing this is the reason the threads were galled (stripped) when you tried to remove the nut. Thankfully, you were replacing the axe ! The nut was NOT cross threaded !
thanks for your comment, have done it quite for a long time n this is what I do first, if you dont completely get the indent in the nut then you ruin the thread, found out later that day, they had tried it the week before n they coulnt get it out
screw driver and garden tool like a small fork but you can try pliers, i tried pliers but was having a hard time or may be I did not have the right pliers, thanks for sharing.
Very good video, I like how you take the shock off instead of the lower control arm 👍
I love these videos. Very clear, straight to the point. I have to do my axle soon.
Thank you
thanks for sharing.
Thanks!
thanks a lot for the Super thanks
Another great video man.
thanks for your great support to the channel.
That exact same thing happened to my axle threads on both sides. All I wanted to do was replace the lower control arm and had to replace the axles as well.
Dude, you have to fully unseat the indent that locks the axel nut in place. Not doing this is the reason the threads were galled (stripped) when you tried to remove the nut. Thankfully, you were replacing the axe ! The nut was NOT cross threaded !
thanks for your comment, have done it quite for a long time n this is what I do first, if you dont completely get the indent in the nut then you ruin the thread, found out later that day, they had tried it the week before n they coulnt get it out
Muy bien, God Bless!
Really helpful video grate job
Glad you liked it! thanks
What tool did you use to install the shaft bearing snap ring?
screw driver and garden tool like a small fork but you can try pliers, i tried pliers but was having a hard time or may be I did not have the right pliers, thanks for sharing.
What was the reason to change axle?
thanks for sharing, it was making noise and basically all the grease had already come out.
Good advice as usual !
thanks for your comment and your time and support to the channel.
Wait!!. ACUAMANS DAD IS A MECHANIC??????
👍👍👍👍👍🌹
That's the passenger side, not the driver side
Passenger side is harder.