Great review man, perfect to the point no bullshit. Every other review is 16 to 35 minutes. To much talk no action. Great tip on greasing o- rings. Learned that the hard way on a evo intake manifold what a bastard that was
From time to time, with all installed, run your finger around the bottom of the filter looking for oil seepage thru the filter media. May even drip along side of motor, exhaust, and right pants leg and boot. If so, remove air filter, wash and reoil, and repeat. When you tire of this process, install an "Oil Breather Bypass Can" to catch said droppings to eliminate mess and excess oil going into engine that fries and collects on top of piston.
Silicone Grease .....on the O-rings . Regular grease will shorten the life of them literally rotting them . No Vaseoline same problem . Petroleum based. Silicone is best.
Did you ever get that solved? I have a 15 fxd that has the same rubber hoses. Figured I didn't need them since the holes they attached to get plugged up with the bolts with the new kit
Great review man, perfect to the point no bullshit. Every other review is 16 to 35 minutes. To much talk no action. Great tip on greasing o- rings. Learned that the hard way on a evo intake manifold what a bastard that was
Great video. Thank you. I just got the Arlen Ness Big Sucker Stage 1 kit for my 2015 Road King. Your video makes it easy.
From time to time, with all installed, run your finger around the bottom of the filter looking for oil seepage thru the filter media. May even drip along side of motor, exhaust, and right pants leg and boot. If so, remove air filter, wash and reoil, and repeat. When you tire of this process, install an "Oil Breather Bypass Can" to catch said droppings to eliminate mess and excess oil going into engine that fries and collects on top of piston.
No rubber vent tubes?
Very good video best one on the big sucker breather as a lot of your videos are cousin brother God bless you stay healthy and safe
Did you have to take tank off to get the new bracket on.
No
Is the arlen ness big sucker kit any better than the screaming eagle high flow kit ??
Why can I not pull the filter off to clean it? I removed the three hex bolts and ots just stuck there. I tried pulling it.. Floss.. WD-40.
I have a Dyna fdx 2008, where ddo I put the air flow sensor???
Do you need to do any fuel performance after adding this air filter?
Sal C yes FP3 is recommended
Yes don't get the air intake without it
Silicone Grease .....on the O-rings .
Regular grease will shorten the life of them literally rotting them .
No Vaseoline same problem .
Petroleum based.
Silicone is best.
I have an iron 883 2014. Do I have to install the two black rubber gaskets as well or just the aluminium one?
Did you ever get that solved? I have a 15 fxd that has the same rubber hoses. Figured I didn't need them since the holes they attached to get plugged up with the bolts with the new kit
T27
Turn the damm music off.