GTI Runs Rough Timing Issue Cam Crank Correlation P0016
Вставка
- Опубліковано 23 лис 2022
- This was a fun diagnosis, the magnetic adjuster and oil control spool valve were having issues leading to the rough running condition.
Automotive Community Discord: / discord
#diy #repair #mechanic #automotive #vw #gti #diagnostictroublecode #help #car - Авто та транспорт
Wait wait wait I follow you on Twitch but just learned that you have a UA-cam channel.
Good video
This is a good video,what causes the spool valve stem to stick out when it is bad?All other youtube videos say to just replace it,but what cause it to go bad /stick out?
not sure why it does that, but I had one with it sticking out, I disassembled the spool valve (popped out the spring on the top that keeps it from falling out) and took it apart, pressed in the button using a vice and it worked fine. Again, not sure WHY it pushes out however maybe it's fixable.
Very interesting video! When you supported the engine with the floor jack, what was the jack pad pressing against, the oil pan? Also, what was it that caused the plunger to be so hard to remove from the oil control valve? Was it metal particles from the metal cam bridge screen? Old enamel or sludge from cheap oil? Or..? Thanks in advance!
Yeah, floor jack, block of wood and the corner of the oil pan (an area that has the most support with corners and wall, don't go for the middle of the pan, that will collapse). Corners save the world!
@@deamonmachine Aha, good tip about using the corner of the oil pan! No concerns about squishing out the oil pan gasket though? BTW, your haircut @1:58 is awesome!
My car does the same, so error code cam shaft position sensor is the timing chain? My car only has 120k kms
I have this code but sadly looks like I need a new timing chain
Did it throw any other codes
one month too late deamonmachine it took me a week to diagnose that valve. on mine the pin was popped out btw so that's another way it fails
I have the 1.8 tfsi and it has misfire 0 error codes in the vcds channel 91 work cycle 45% and in the settings it shows 35 kw specified and 35 kw current and it lacks a lot of power
Where u locates
Far away in the usa