Them little numbers mean a lot for any engine mines the same way I just got a new cylinder and piston kit It was going to coast more for me to get mine bored out so that why I got me a new cylinder I just got done polishing my head and going to do the exhaust chamber
True, .050" on a little single cylinder is something compared to a big block. I remember getting the cylinder bored for $50, which seems to just about cover setup so it was damn cheap. I forget the cost on the piston and rings but it wasn't bad. It still runs great!
I was thinking about shaving the head on mine but I think I’ll leave it alone there ant much head there have u ever done the crank seals Befor is it’s a bad job to do
@@heliarche yeah it my piston kit was 38 dollars and the cylinder was 134 so I just got it cuz a guy I no was going to bore mine out but he wanted 100$ to bore it and port it out So I just got a new one
Them little numbers mean a lot for any engine mines the same way I just got a new cylinder and piston kit It was going to coast more for me to get mine bored out so that why I got me a new cylinder I just got done polishing my head and going to do the exhaust chamber
True, .050" on a little single cylinder is something compared to a big block. I remember getting the cylinder bored for $50, which seems to just about cover setup so it was damn cheap. I forget the cost on the piston and rings but it wasn't bad. It still runs great!
I was thinking about shaving the head on mine but I think I’ll leave it alone there ant much head there have u ever done the crank seals Befor is it’s a bad job to do
@@heliarche yeah it my piston kit was 38 dollars and the cylinder was 134 so I just got it cuz a guy I no was going to bore mine out but he wanted 100$ to bore it and port it out So I just got a new one
After putting bearing on not pressed on there about end play as old ones could be somemissing 4cycle one cylinder ?
Let me get on the same page as you. You're saying that you installed new bearings and the end play is pretty much the same as the old ones right?
I have an old cart with the same engine and issue. Any chance you could tell me where to find a manual and rebuild kit please.
Kirby
Look up the engine and model number of your cart. Ask around on Buggiesgonewild.com and they can help as well.
Thank you, much appreciated
@@flywiseman I got mine on eBay
I have the same issue. Did rebuilding the top half help with it being a dog?
Absolutely. This engine was extremely worn out though. I had the jug bored and got an oversized piston.
mr hellarche what wood think ok end play for crank shaft ?
I can't really tell you for sure but I doubt it would be more than ten thousandths of an inch.