When leveling, remember that the Laser may be sitting on a surface that is not necessarily level. So the position of the level bubble on the tumbler should be the same as the position of the bubble on the laser module.
@@FreshStartCustoms I don't mean like that, I mean where it actually sits in the machine, should I have to build something thats straight that fits perfectly in the machine and lay it against it so that its straight? I'm scared to line it up by eye lol i'm thinking its gonna come out crooked
@@jagbuddy I just retighten the cup flush again. I noticed it was loose after filming that section so I make it flush in the chuck and tightened it again
When leveling, remember that the Laser may be sitting on a surface that is not necessarily level. So the position of the level bubble on the tumbler should be the same as the position of the bubble on the laser module.
@@sgriffin130 true, I feel like all lasers should be on a level surface already however for best results.
@@FreshStartCustoms Yes I agree. But there's level and then there's level😀
@@sgriffin130 ha ha yeah
How do u know the Rotary is completely straight? I'm worried when I engrave its going to be all crooked if I didn't put it in straight enough
@@FabstaPizza you can put a small level on it
@@FreshStartCustoms I don't mean like that, I mean where it actually sits in the machine, should I have to build something thats straight that fits perfectly in the machine and lay it against it so that its straight? I'm scared to line it up by eye lol i'm thinking its gonna come out crooked
@@FabstaPizza yea you might be able to attempt that too.
I use a carpenter triangle to square up the ra2 with the laser head support bar
Did you make the engraving program?
@@boltgodzeus9021 do you mean the file? If so yes that’s my file but I don’t have it listed anywhere right now
@@FreshStartCustoms is it difficult to make programs files?
@@boltgodzeus9021 it can take a decent amount of time depending on what type it is. I use illustrator to make them.
@@FreshStartCustoms good job! 👍
@@boltgodzeus9021 thank you
How did you get rid of the Wobble?
@@jagbuddy I just retighten the cup flush again. I noticed it was loose after filming that section so I make it flush in the chuck and tightened it again
What was the run time to engrave something that size?
@@blakemccarthy1723 I believe it was only like 15 mins. Somewhere around there.