5.4 coolant crossover

Поділитися
Вставка
  • Опубліковано 24 гру 2024

КОМЕНТАРІ • 17

  • @rosepatton592
    @rosepatton592 2 місяці тому +1

    cut the corner. I didn't. did not know did one side only. thought there was a pipe in left side sticking down your videos are fantastic 10/10

  • @davestewart9146
    @davestewart9146 8 місяців тому +1

    Taking that little bit of plastic out saves a whole lot of time removing the intake, nicely done 👍😁

  • @akoo9904
    @akoo9904 4 місяці тому

    This is awesome. Can you please explain a bit more the purpose of the break clean.

  • @joseph_johnson9266
    @joseph_johnson9266 2 місяці тому +1

    GOD BLESS... Great video, much appreciated!!! I have the exact same issue right now this day, 10/03/2024, I see exactly what I need to do but what part did you grind down and with what tool? Working on a 2010 Ford Expedition EL King Ranch 5.4 v8... I already have the 2 gaskets, changed the thermostat about 3 mths ago, should I change it again? Thanks a bunch...

    • @AutomedicGarage
      @AutomedicGarage  2 місяці тому +1

      @@joseph_johnson9266 I wouldn’t mess with the thermostat if you just recently did it. You just trimming the corner of the crossover tube so it can slide out from j see the intake. I just used my side cutter with a cut off wheel.

  • @tongtongwang
    @tongtongwang 3 місяці тому +1

    I cannot thanks enough for this video. Really appreciate !

  • @mylawnnstuff4315
    @mylawnnstuff4315 Місяць тому

    I believe i have a leak in the same spot. going to attempt this today, a new gasket just arrived in the mail. i think the worst part of the whole job is blowing out the coolant from the spark plug wells 😂

  • @DoesItTrack
    @DoesItTrack 3 місяці тому +3

    i feel like i've seen this somewhere? 😁

  • @tongtongwang
    @tongtongwang 3 місяці тому

    Is it the same for 2014 expedition

  • @meganchristmas8752
    @meganchristmas8752 2 місяці тому

    What type of grease? I did all but can’t get pipe back under manifold area.

    • @meganchristmas8752
      @meganchristmas8752 2 місяці тому

      The pin from manifold keeps popping out and can’t get the crossover pipe back in, so frustrating

    • @AutomedicGarage
      @AutomedicGarage  2 місяці тому +1

      @@meganchristmas8752 any type of grease

  • @jasonschmidt6988
    @jasonschmidt6988 12 днів тому

    Wondering if this will work on 2v?

    • @AutomedicGarage
      @AutomedicGarage  12 днів тому

      @@jasonschmidt6988 good question, I’d have to look

  • @montegrounds7364
    @montegrounds7364 3 місяці тому

    I OVER TORQUED NOT ENOUGH TO CRACK THE MANIFOLD...😢 NOW ITS REDO TIME..WISHED ID WATCH THIS SOONER..GRINDING CORNER WORKS JUST FINE..

  • @zeepers
    @zeepers Місяць тому

    Awesome!!!!!!