I have used motul for 35 years. I stick with what works. Most 4 cylinder bikes that dont call for synthetic. I use motul 5100.4 of my personal bikes have 40k on them.oil changes every 3k
Little more thane 3 1/2 quarts.pour in 1/2 of fourth quart check dipstick with bike upright. Then pour in a little at a time . Checking it on dipstick should be in between 2 lines on dipstick. Don’t overfill it. Hope this helps
As long as its within the low and high line. It happens sometimes. I usually just pull oil filter and dump that oil out.then check level. Might have to do it few times. Easier than pulling drain plug. Take your time. Good luck
Thank you that was very helpful...
Very helpful! ☺️
Very helpful! Just bought a 2003 CBR 600rr. What type of oil do you recommend?
Motul 5100 .used it for many years.no issues. I stick with what works.i change my oil every 3k or 4 months whatever comes first
Where can you find the crush washer for this specific bike?
What is the part number to the oil filter ?
K&n # 204 or 303
Hey boss, what oil are you running?
I have used motul for 35 years. I stick with what works. Most 4 cylinder bikes that dont call for synthetic. I use motul 5100.4 of my personal bikes have 40k on them.oil changes every 3k
Wait so does it take 3 quarts or 4?
Little more thane 3 1/2 quarts.pour in 1/2 of fourth quart check dipstick with bike upright. Then pour in a little at a time . Checking it on dipstick should be in between 2 lines on dipstick. Don’t overfill it. Hope this helps
Assuming you also changed oil filter as well
@@motosolutions540 thanks for the response. Also what oil do you recommend for an 03 cbr 600rr just picked mine up couple of days ago.
@@Ifeelgreyt1738 i use motul 5100 10-40 .unless bike says use full synthetic i wouldnt.jus change oil at 3 k you’ll be good
How much oil u put?
Almost 4 quarts
Sorry for late reply. Start with 3 1/4 quarts then check level. Add as needed
What happens if oil level is to to top of level. Aka slight overfill.
As long as its within the low and high line. It happens sometimes. I usually just pull oil filter and dump that oil out.then check level. Might have to do it few times. Easier than pulling drain plug. Take your time. Good luck
Make sure you put oil filter back on,then start the bike. Let it run few minutes, turn bike off .let it cool down then check oil
@@motosolutions540 ok. It's right below the full top line mark.
Your fine then