Mitsubishi Pajero Sport accessory harness installation video
Вставка
- Опубліковано 11 вер 2024
- This video is an instructional video to show how to install an accessory harness into the Mitsubishi Pajero Sport
You can find dual battery kits to suit this vehicle on our website.
www.aussiedrif...
Great commentary, to the point but with detailed explanation. A lot of people doing these videos automatically assume that everyone is familiar with pulling panels and running cables through firewalls. Your videos give people the confidence to get a kit and have a go themselves.
Thanks mate, glad you found it helpful
Best video on this subject.
Everything explained and shown.
Thanks for taking the time to help.
No worries, glad it was helpful mate
Thanks for this video. You must have the smallest hands of any known body. It took me about 2 hours to get the wire through the grommet. I ended up putting a flat screwdriver through the grommet to give a space for the cable. There was not room for two hands between the brake actuator near that grommet. I did contemplate putting a hole in the grommet but persisted and it appears to work. The hole in the rear was the easiest part.
Ha ha, You can probably tell in the video that as an over 6 foot guy i certainly dont have the smallest hands in the world 😜 But i have done it a few time which makes it easier. Modern engine bays are pretty tight but hopefully the video explained the steps for you.
Brilliant video. Thank you for taking the time to create and upload it for us. When I receive my Pajero, I'll be ordering everything from you. 👍
Glad it was helpfull mate
Great video, very helpful. After installing one of your excellent kits (without breaking or losing any factory clips, thank you again) I reckon I know how the installer got that cut on his left hand as well, the underdash of the pajero sport has some sharp bits hey.😁
Ha, Glad the video was helpful mate, hope you didn't get a cut yourself.
Great video, helped me figure out how to run wiring kit for my DCDC charger. Cheers!
Glad it was helpful mate
Thanks for the videos.....huge help
Glad it was helpful mate. 👍
Really helpful. Thanks heaps.
Glad it helped mate
Do you by any chance know which is the speaker wires?? I can’t find any, took off the passenger trim floor and cannot figure out which one to look for. Need left rear back wire colors so I can tap into them
Excellent video with all the detailed description / camera close ups!! Subscribed! :)
Can these accessory wiring harnesses be bought as is for the Pajero Sport? Or need to make it yourself? Does the vehicle battery connect to the redarc which then connects to the auxiliary battery to charge it?
I’m trying to decide whether to do a second under bonnet battery to power fridge etc; using a LiFePo4 / Redarc BCDC1250D, or if I should just buy a portable battery pack instead - any thoughts on this?
Hi Damian. Glad your liking the videos mate. We make the full dual battery kit for this car and these videos are part of the video tutorial to help with installation. You can purchase the kit from the link below www.aussiedriftertouring.com.au/shop/triton-pajero-kit
We also have kits to aid in seeing up a battery in the rear of the car as well, there is upsides and downsides to each setup. feel free to give us a call to discuss options.
0413970616
Hey mate good video and it's so helpful ...just wanted to know how to route the cable if I want to install the Anderson or accessory unit near the back bumper as I want to use Anderson for my trailer
This video might help you mate ua-cam.com/video/sALTkaeH-Bo/v-deo.htmlsi=hGFQbcfib6nknNWg
Great video mate. I’ve watched the battery tray video but can’t seem to find the video you mentioned about the red arc mount?
Cheers.
Hi mate, Sorry its not on the you tube channel at the moment due to an issue but you can watch it here www.aussiedriftertouring.com.au/shop/triton-pajero-kit
Is this the same installation steps for the QE (2016+) model - compared to the QF you do in the video?
Sorry mate this kit only fits QF 2019 on
@@AussieDrifterTouring could you run an Anderson cable through the same chassis openings for the QE or is it a different internal setup?
Is there an earth wiring location or bolt in the back somewhere?
yer there would be, you can earth to any solid bolt on the body if needed.
Where do you buy all the accessories from.
You can buy the whole kit here www.aussiedriftertouring.com.au/shop/triton-pajero-kit or just the accessory harness here mate www.aussiedriftertouring.com.au/shop/accessory-harness