Making custom sun shade for Humminbird Helix 7 fish finder

I tried some heat molding of abs plastic for the first time and this is the result. Wanted the sun shade to be a single piece, to be non-destructive to the unit itself, and for the right side controls easily accessible with a thumb. No velcro or double stick tape that could gunk up the fish finder over time. There’s some neoprene foam placed on the underside of the shade to seal it a bit better. Was a quick and dirty prototype but it ended up fitting fairly well.

[@rickhunter3323]

Nice job. Wish they factory made these. Plenty of people want them.

[@darylwchan]

Great job!

[@antonioesposito9831]

Would purchase one from ya!

[@12restoration]

Nice job, I'll take one.

[@BWWGL9]

Send me one! Lol,,,,,,,, nice job

[@chrismcclear4290]

Hi Pete, Would you be open to sharing your pattern? nice job on the video!!

[@petekvidera6836]

Thanks! Here's the pattern, which I would use as more of a rough guide than an exact pattern.
www.dropbox.com/s/5yjsguqrvd22izk/humminbird_guide.pdf?dl=0
It took a lot of bending and stretching, and then more bending and more re-stretching on top of that to make it work.

[@flicknfishwithanthony]

Hey Pete is it possible I could get the template for the cover so I could make my own ?

[@LanceCustomWoodcraft]

Pete Kvidera, nicely done! Did you use 1/16" thickness or 1/8" for your ABS plastic?

[@petekvidera6836]

It was 1/16"

[@picassooutdoors7536]

Anyway you can share your template? Or we can buy from you?

[@chrisbianco1354]

Great job can you pls tell me what material you use ?

[@petekvidera6836]

ABS plastic sheet

[@zimmermanseth]

Any interest in selling one?