2nd Gen Sequoia Switch Plate Mod

I needed an option to add more switches to my 2014 Platinum model that already had all existing switch holes occupied. This is an easy mod using a stock part you already have to add more switches to your 2nd Gen. Sequoia & keep it factory looking. These are the part numbers for the items I purchased:
* Base Switch Hole No. 2 (the three panel plate): 55447-0C011 (need 2...or just 1 if you want to put it in between the two existing ports)
* Lower Dash Bezel w/ Cubby: 55434-0C020 (you only need this if you want to keep your existing one intact)
Once I cut out the rectangular part of the lower dash to make room for the switch panels, I did have to sand down the inside on both sides to get rid of the radius curve so the panels would fit snuggly. I did a little sanding at a time until the fit was good, and then I epoxied everything together.
I ordered the switch plates from here: www.oemgenuineparts.com/oem-p...
The cubby I bought used off eBay.