DIY Install Guide to the Rear Motor Mount Upgrade for Focus ST / RS
Вставка
- Опубліковано 14 вер 2018
- Installing a Rear Motor Mount on my 2017 Ford Focus ST. It's a great upgrade that I highly recommend!
Get a similar mount here: amzn.to/2xdvCty - Авто та транспорт
Good upgrade, calms down the wheel hop while accelerating 👍/ I had to grind corner off a nut so would not rub. Easy fix. Shallow nut should of been supplied.
For sure
Great video...can’t wait to feel the difference after the install
It's gunna be huge
After the install there is such a noticeable improvement! Gotta drive it to know. Not to mention the stock mount had rips in it on each side.
Great videos. Glad I found your videos.
I am glad you did too, enjoy!
Just did mine tonight. Will drive her tomorrow as I need a beer and it's wet outside lol. Great vid mate.
How did it feel?
@@JrsGasolineAlley slightly more vibration through your feet. But I'm told it needs atleast 1000 miles to bed in. I'm very pleased. The mountune does have very good reviews. I woukd recommend as gear changes are more crisps and yep! Gets rid of wheel hop. Had a play tonight and it's much better. If you want to drive your st hard sometimes.
Great video my friend, I have been debating on installing this or not.
Glad you liked it, I certainly recommend the RMM. It is totally worth it.
@@JrsGasolineAlley was it much different to the one you took off mate. How was the nvh also cheers. I have the updated one you took of on my focus RS MK2 seems good so far
Those 13mm bracket bolts, there are like 5 of them how many ft/lb of torque? No need to torque them just tighten them up real good by hand?
Nice video!!! Regards from México ;)
Cheers!
My bolt that came with my mount doesnt seem to want to clear that bolt on the back?
do you actually need an impact or would a breaker bar work ?
where did you get the torque values ? also great video
Mountune's instructions
Thanks ..So is there an improvement?
For sure!
@@JrsGasolineAlley cheers for upload m8 iv just ordered one 👍
What way should the flat side face?
Branding goes out.
i installed this exact motor mount i have alot of vibration at idle kind of annoying. does it break in?
I have one, the mild idle vibration goes away completely. Don't remember how long it took... maybe a couple of months?
@@VikVaughan when I turn on the ac forget about it. it's like I'm driving a go kart so much vibration. I'll have to go under the car and see if they Installed it upside down. Otherwise it's coming out
@@tbone8ty Did u sort it?
@@tbone8ty I bought a car with one already installed (Steeda), and hate the low-speed vibration--it shakes the whole dash. I'm putting a stock one back in.
@@VikVaughan Any change seems very unlikely. I bought a car that already had one installed and can't wait to remove it--the vibration is shaking the dash cluster apart. Even worse with A/C on.
What brand impact wrench you was utilizing in this video?
Rigid Brushless
absolutely pointless, reinforced Bush on chassis, but still connected by a worn out inferior rubber Bush that will still cause the same amount of movement 🤣
people are so gullible