1992 Geo Metro 1L 3 cyl engine rebuild playlist part 2 Pistons going in
Вставка
- Опубліковано 20 лис 2020
- Watch as the 1L 3 cyl Geo Metro engine gets it's new pistons installed
Please consider being my patreon
/ . .
Amazon links to products I use and recommend
If you use my links to get to the Amazon store I will get a small commission (at no cost to you) from whatever you purchase which greatly helps the channel. Please keep a link on your desktop to make it easy to get to my store. Thanks
Battery tester
www.amazon.com/Schumacher-BT1...
www.amazon.com/dp/B00006LVEU?...
www.amazon.com/dp/B081CMY3PX?...
www.amazon.com/dp/B003V5ITJA?...
www.amazon.com/dp/B00A9ZNE7C?...
Vampliers
www.amazon.com/VAMPLIERS-Pate...
Carb cleaner
www.amazon.com/Gumout-8000022...
Carb dip
www.amazon.com/Berryman-Produ... - Навчання та стиль
Re installing pistons...
I had a similar problem about 35 years ago rebuilding a 1962 Rambler engine. It, like your engine, had just come back from the machine shop. Tried to install the pistons with a ring compressor just like that one. It really kicked my ass! Pistons just wouldn't go in.
Asked my dad if he had any advice. He suggested chamfering the tops of the cylinders just slightly. Took my Dremel tool and a cone-shaped stone, and tried on one cylinder. Piston went in slicker than owl shit! Did that on the rest of the cylinders...made the job easy. Of course, make sure you clean up after chamfering. BTW, the engine ran fine afterwards.
Might have to do this, I'm rebuilding my motor still in the car lol
great video
Thanks!
Can you doo this inside the car
Maybe, but the engine is so light, you can just drain the fluids, remove the manifolds and heads, then lift the block out by hand if you don't have a hoist. I'm of average strength and was able to remove it easily with a helper. You should at least pick up the cheapest small engine stand you can find though if you don't already have one. They're only like $60-70 and are well worth it.
To do a proper job you need to take it to the machine shop to have the cylinders bored and they check all the bearing clearances for the mains, acid clean the engine and coolant passages, check for cracks etc. If you were just fixing- not rebuilding then an in frame repair is possible but this engine comes out so easy it might be better to just pull it out
Stock pistons?
Where are you
I need rebuilt my motor too geo Metro 1992
You can do
@@jessiwarner7106 they are very easy to rebuild, I did mine in the car still in one day