props to you Krookz for taking the initiative to take this video. hopefuly it will help out other taco owners in the future when it comes to getting parts replaced due to driveline vibes. maybe one day toyota will finally admit there really is a problem here!
Same thing on my 09 Tacoma with 33's and a 3 inch lift all around. Thought it may be the carrier bearing but after doing a full driveline service (carrier bearing, regreasing slip yoke, and replacing all 3 U-joints) it is still there. I think it may be a structural issue and the cross member that the carrier bearing sits on needs additional support.
where did you source it? I have a slight vibration from my 2012 tacoma. Leveling kit and two inch rear blocks. I put in a carrier bearing drop and axle shim but it still is evident. Thanks.
The problem is the angle the ujoints are running in ..... with the 2 yokes right after the carrier bearing being almost in a straight line , this will cause the vibration ... I would try removing the spacer on the carrier bearing , then check to see what angle it is sitting at .. then check the angle at your axle yoke they should be the same .. But ............. You want the driveshaft to point down to the axle , not be in line with it.. I would remove the center bearing drop spacer , and remove the shims under the leaf springs (if you installed any) . Then drive it ... it should clear up some if not go away ...... The angle is all wrong on this driveshaft ....
Do you get this in all gears at the same rpm? Or only at a specific road speed (or driveshaft rpm) Im asking because I get this in all gears in the same rpm range..
i have a 2012 6spd with a lift, original suspension, man at 120kmph the seats are shaking, my cheeks are jiggling, at 130kmph lookout feels like my truck is going to come apart. 21,000km on it. in neutral when coasting to a stop there is a rattle coming from underneath, taken it to the dealership 3 times for this and they cant find what the rattle is
I have a 2012 tacoma and its had the take off vibes since new off the lot. I havent modified the suspension in any way. I test drove another truck similar and it did the same thing. Looks like Toyota failed Driveline 101.......
See TOYOTA Customer Support Program ZH2 warranty extension. They replace u joint and hanger and possibly drive shaft for free. Work warranted for 12 years.
Weak carrier bearing crossmember and two piece driveshaft, reinforce the crossmember. or remove the carrier bearing crossmember and two piece driveshaft and replace it with Tom Woods drive shaft.
Had a tundra that did this since new, 6 in lift with 35's.. Damn thing rattled and shuttered and fuckin sputtered everywhere. Tried EEEEVERYYTHING!!!!!! Spacers, drop brackets,washers...etc..I had it for two months and sold that useless p.o.s. there IS NO FIX FOR THIS!!! Sell it and buy a CHEVY like I did. Happy as a pig in shit now!!!:)))))))
props to you Krookz for taking the initiative to take this video. hopefuly it will help out other taco owners in the future when it comes to getting parts replaced due to driveline vibes. maybe one day toyota will finally admit there really is a problem here!
also, weak rear leaf spring packs, replace them with a stronger/ better aftermarket set. check the angles/geometry, install shims if needed.
hey man, I have a '10 with the same problem.... i think, its it shake your steering wheel and pretty much the whole truck?
Same thing on my 09 Tacoma with 33's and a 3 inch lift all around. Thought it may be the carrier bearing but after doing a full driveline service (carrier bearing, regreasing slip yoke, and replacing all 3 U-joints) it is still there. I think it may be a structural issue and the cross member that the carrier bearing sits on needs additional support.
I believe you have to install shims on your carrier bearing bracket to compensate for the lift and to re angle the drive shaft.
where did you source it? I have a slight vibration from my 2012 tacoma. Leveling kit and two inch rear blocks. I put in a carrier bearing drop and axle shim but it still is evident. Thanks.
You need the Oem Spicer or Dea carrier bearing, no aftermarket
The weird thing is that I've put the truck on axle stands, applied hand brake to simulate load, and it doesn't even have a hint of it???
what was your measurements on the one u got?
it looks like the carrier bearing is shaking?? I don't know too much about these trucks!
you fix this? what about a carrier bearing drop??? thx home skillet.
The problem is the angle the ujoints are running in ..... with the 2 yokes right after the carrier bearing being almost in a straight line , this will cause the vibration ... I would try removing the spacer on the carrier bearing , then check to see what angle it is sitting at .. then check the angle at your axle yoke they should be the same .. But ............. You want the driveshaft to point down to the axle , not be in line with it.. I would remove the center bearing drop spacer , and remove the shims under the leaf springs (if you installed any) . Then drive it ... it should clear up some if not go away ...... The angle is all wrong on this driveshaft ....
Disculp como lo arreglaste ???
2 washers
I just started experiencing this in my stock (no lift) 07 Tacoma 4x4 TRD Sport, 175K miles. Any advice?
Service drive line by replacing carrier bearing, all 3 u-joints, and grease slip yoke
@@Googladesh or have a one piece driveshaft built
so what can we do to fix this prob...i got this on my 06 with a 3" lift....
Do you get this in all gears at the same rpm?
Or only at a specific road speed (or driveshaft rpm)
Im asking because I get this in all gears in the same rpm range..
Crossingpoint only first gear in my 2017 Taco
i have a 2012 6spd with a lift, original suspension, man at 120kmph the seats are shaking, my cheeks are jiggling, at 130kmph lookout feels like my truck is going to come apart. 21,000km on it. in neutral when coasting to a stop there is a rattle coming from underneath, taken it to the dealership 3 times for this and they cant find what the rattle is
That cross member needs to be Rene forced my friend did it and it fixed the problem
I have a 2012 tacoma and its had the take off vibes since new off the lot. I havent modified the suspension in any way. I test drove another truck similar and it did the same thing. Looks like Toyota failed Driveline 101.......
Austin Kalenda my 2017 Taco has the same issue. Sucks! Only happens in first gear.
See TOYOTA Customer Support Program ZH2 warranty extension. They replace u joint and hanger and possibly drive shaft for free. Work warranted for 12 years.
Weak carrier bearing crossmember and two piece driveshaft, reinforce the crossmember. or remove the carrier bearing crossmember and two piece driveshaft and replace it with Tom Woods drive shaft.
Tom Woods driveshaft....that is the answer.
@@snowhiterover yeah and you will get noticeable differences in more torque out put vs the two piece shaft.
Geeze… I’m never lifting my truck.
Had a tundra that did this since new, 6 in lift with 35's.. Damn thing rattled and shuttered and fuckin sputtered everywhere. Tried EEEEVERYYTHING!!!!!! Spacers, drop brackets,washers...etc..I had it for two months and sold that useless p.o.s. there IS NO FIX FOR THIS!!! Sell it and buy a CHEVY like I did. Happy as a pig in shit now!!!:)))))))