I read the comments and could only see congratulations and appreciation for your work Matt.. it’s truly amazing and I can only say the same things. Thank you and keep up the good work! I can’t wait to see the Rob’s tutorial about this build!
Thank you Matt for letting me and us learning from you. I regard you as the best teacher on the internet because your explanations, your tips and hints, your way of taking about things that could happen makes it easy to learn and understand. Whenever I made a mistake, their is a great possibility that you have mentioned it before. I hope you will never stop doing teaching. Good luck for all of your ways
Thank you for doing this the free online woodworking school. You’re a amazing teacher. I love all the content you put but you doing fine woodworking is amazing.
Matt your teachings and knowledge you are passing to us is priceless. Techniques that are universal in any project and making it easy to understand the why and the how. Thank you so much for these courses.
One thing I find helps when chiseling baseline is to go 2/3 through from faceside first then finish on backside - if any breakout happens it will be deep on the inside
Thanks for the video! When using the rebate plane on the bottom of the drawer, is there a reason why you didn't flush the workpiece to the edge of your bench and allow the fence of the plane to also run along the apron of the bench? Seems like that might be helpful with such a thin piece?!
I read the comments and could only see congratulations and appreciation for your work Matt.. it’s truly amazing and I can only say the same things. Thank you and keep up the good work!
I can’t wait to see the Rob’s tutorial about this build!
You're a legend Matt Estlea
Thank you Matt for letting me and us learning from you. I regard you as the best teacher on the internet because your explanations, your tips and hints, your way of taking about things that could happen makes it easy to learn and understand. Whenever I made a mistake, their is a great possibility that you have mentioned it before. I hope you will never stop doing teaching. Good luck for all of your ways
Thank you for doing this the free online woodworking school. You’re a amazing teacher. I love all the content you put but you doing fine woodworking is amazing.
Matt your teachings and knowledge you are passing to us is priceless. Techniques that are universal in any project and making it easy to understand the why and the how. Thank you so much for these courses.
One thing I find helps when chiseling baseline is to go 2/3 through from faceside first then finish on backside - if any breakout happens it will be deep on the inside
Thank you again for this great video series with the amazing number of tips!
Beautiful drawer love your attention to detail
Lots of information as always.
Thanks for sharing.
Thanks for sharing your videos always are very helpful
good job, thanks
Thanks for the video! When using the rebate plane on the bottom of the drawer, is there a reason why you didn't flush the workpiece to the edge of your bench and allow the fence of the plane to also run along the apron of the bench? Seems like that might be helpful with such a thin piece?!
Great vid. 1 question, do the thru dovetails on the back have any mechanical advantage. 😃
This is really useful. For the rebate on the front edge of the bottom panel, how did you do this neatly without a nicker on the plane?
What were the little blocks you put under the clamps for? (I am useless at dovetails and would likely make this with a lock joint, but I am curious).
2:14 just me or is that a funny place for the B?
Why you use clamps instead vises?
I prefer to make with WoodPrix plans.