How to fix a pressure washer gun trigger.

Поділитися
Вставка
  • Опубліковано 30 лис 2024

КОМЕНТАРІ • 13

  • @danielbrowniel
    @danielbrowniel 2 роки тому +10

    I'm no rocket scientist but the O ring probably got carried by the water from a place where the water came from.

  • @BiggMo
    @BiggMo 10 місяців тому +3

    Brass is soft. Don’t use an adjustable wrench on brass fittings, you need well fitted fixed wrenches. Ideally a 6 point box wrench,

  • @shaneh9524
    @shaneh9524 Рік тому +3

    You can see the o ring seat down in the gun itself when you held it in front of the camera

  • @8SecSleeper
    @8SecSleeper 8 місяців тому

    Could be from a check ball for the pressure washer. Theres two for each of the pressure washer pistons. Itll he down on pressure compared to new.

  • @MasteringHow-To
    @MasteringHow-To 2 роки тому +6

    Going to leak without that o ring…

    • @rebeccaelya9966
      @rebeccaelya9966 2 роки тому

      I wast thinking the same thing .

    • @capicolaspicy
      @capicolaspicy 2 роки тому +1

      Unless that o-ring broke and then got blown through the pump outlet and jammed there in the trigger valve, though how it got by the side of the ball bearing and into the spring body is hard to figure!

    • @luiscarballolopez3313
      @luiscarballolopez3313 2 роки тому

      You wrong it does not need o ring it is only the ball

  • @TheDroneOperator.
    @TheDroneOperator. 7 місяців тому +1

    is this a joke? you didnt see the o-ring on the second one at the base of the spring?????

  • @sierratrey
    @sierratrey 2 роки тому +1

    Super simple yet extremely flawed design. The brass will crack due to stress. it won’t take much torque either.

    • @pantac4493
      @pantac4493 Рік тому +2

      Every pressure wash gun I seen is made like that. It doesn’t crack

  • @prakashmr9817
    @prakashmr9817 2 роки тому

    Hi super

  • @luisaponte-z7e
    @luisaponte-z7e 11 місяців тому

    Hola