Do you have an '03 with this exact oil rail and 10.9 bolts? Do not listen to the torque specs if you have 10 mm head socket like mine. If it's a torx you can go tighter. I didn't do a video on it but The bolts can only take about 12 torque pounds. Not the 33 the internet was telling me.
Seem to be 8mm bolt head. Haven’t put a socket on it yet. When I saw that I just stopped because I need to change #7 injector and the bolts by the heater box were a bitch and I wasn’t putting it back together just to go to Home Depot not even 2 miles away to come back and take it apart again
@@billycarroll3667I bet the passenger side is a real pain! Yes 8mm sounds right. Just don't put them back on with the torque wrench and try to be as consistently hand tight as possible. I tried twerking one to 33 ignorantly and ripped the head off. Thankfully threads were above the block but I had to remove the rail again which made it another day project.
What tool is that? I’m in the middle of doing mine and I need it done today. Where can I buy one
The tool I used was a Ryobi oscillator bit. Best wishes for you. Any hardware store should have you set.
Do you have an '03 with this exact oil rail and 10.9 bolts?
Do not listen to the torque specs if you have 10 mm head socket like mine.
If it's a torx you can go tighter.
I didn't do a video on it but The bolts can only take about 12 torque pounds. Not the 33 the internet was telling me.
I have an 03. Just like you said all the videos only show newer 04s and up and when I took the valve cover off I was like well this looks different.
Seem to be 8mm bolt head. Haven’t put a socket on it yet. When I saw that I just stopped because I need to change #7 injector and the bolts by the heater box were a bitch and I wasn’t putting it back together just to go to Home Depot not even 2 miles away to come back and take it apart again
@@billycarroll3667I bet the passenger side is a real pain! Yes 8mm sounds right. Just don't put them back on with the torque wrench and try to be as consistently hand tight as possible. I tried twerking one to 33 ignorantly and ripped the head off. Thankfully threads were above the block but I had to remove the rail again which made it another day project.