Ford 1900 - Hydraulic Fluid Change

Поділитися
Вставка
  • Опубліковано 24 гру 2024

КОМЕНТАРІ • 16

  • @bcain5823
    @bcain5823 Рік тому +1

    I have a Shibaura SD1840D that looks similar to this. However, I don't see any drain plugs under the tractor. I have a fill hole for the rear lift and frontend loader under the seat and another like yours for the transmission. Both have water, but not sure if these areas are connected. It looks like I might have a drain plug on the right side for the transmission but not sure until I loosen it.

  • @user-wi6id9rk9p
    @user-wi6id9rk9p 8 місяців тому +1

    im getting brownish discharge from my left rear axle where the rim mounts, the rear 3 pt hitch barely lifts, the front all works fine and fluid shows full by shifters, I was hoping there was more than 1 location for hydraulic fluid?

    • @canadianwrench
      @canadianwrench  8 місяців тому

      Is the brown discharge oily?
      Maybe an axle seal.
      Is your Hydraulic oil brown? If not - maybe some rust being pushed out.
      Same tractor?
      Some tractors may have separate systems.
      Changing fluid would be first thing - clean your pickup screen too!!
      After that - maybe a restriction to 3ph making it slow.
      Good luck

  • @paularmstrong4928
    @paularmstrong4928 2 роки тому +2

    Thanks

  • @TeeWadeG
    @TeeWadeG 10 місяців тому +1

    What fluid/lube did you use to refill ??
    Im In central Oklahoma

    • @canadianwrench
      @canadianwrench  10 місяців тому +1

      I used AW 32.
      Unfortunately more than one 19L (5 gallon) bucket of fluid is needed.
      Tractor supply usually good price.

    • @TeeWadeG
      @TeeWadeG 10 місяців тому +1

      @@canadianwrench thank you

  • @wagzz
    @wagzz Рік тому +1

    Great video. Do you know what pto seal and gasket I could buy for a 1900? I'm having a hard time finding a PTO seal that mentions the 1900. I'm leaking fluid out of the pto shaft when on a hill.

    • @canadianwrench
      @canadianwrench  Рік тому +1

      I’m not sure which seal.
      If there is a number on the old seal it would be easier to find.

    • @wagzz
      @wagzz Рік тому +1

      @@canadianwrench Oh hey, thanks for the quick response. That's cool, I think I found it after a bunch of research. Part# SBA050202340 for the seal and SBA322990381 for the gasket. Just bought a ford 1900 today and have some fixing to do on it. you see any problems using a universal tractor hydraulic/transmission oil?

    • @canadianwrench
      @canadianwrench  Рік тому

      Great find on seals.
      I believe I used AW32 - I will double check tomorrow.
      I also know I needed more than one 20L pail of oil.
      I think 25L.

  • @DrewWisdom-f3n
    @DrewWisdom-f3n Рік тому +1

    I changed fluids on mine now have no use in any of hydraulics may air in lines any ideas?

    • @canadianwrench
      @canadianwrench  Рік тому

      Air should work out fairly quick.
      I’d check:
      Right fluid?
      Right amount of fluid?
      Did you clean up both screens?
      Pump issue.

  • @boltts86
    @boltts86 2 роки тому +2

    GRAAAAMPA

  • @bobmcranor1049
    @bobmcranor1049 2 роки тому +2

    Had a John Deere it was getting in the shifter boots

    • @canadianwrench
      @canadianwrench  2 роки тому

      Yes - agreed.
      I actually put a thick wad of grease under boots.