Saab 9-3 Hella Xenon Projector Replacement for new EvoX-R projector | Headlight Replacement
Вставка
- Опубліковано 26 гру 2016
- Saab 9-3 Hella Xenon Projector Replacement for new EvoX-R projector | Headlight Replacement
retrofitlab.com/products/saab...
Check out our new Facebook group: / europeanheadlightcommu...
0:11 Heat the headlight to soften the permaseal. Break the sealing with a screw driver and permaseal tool.
2:24 Remove the turn signal reflector
2:40 Remove the reflector/projector unit and replace the projector
3:00 The difference between old (top) and new (bottom)
3:05 Mount the unit in the headlight, remove the permaseal, add butyl and heat the headlight again to reaseal it.
Any questions? Contact us directly!
www.retrofitlab.com
info@retrofitlab.com
+31 (0)341-820220
Retrofitlab.com
Tolweg 2W
3851SK Ermelo
Netherlands
These products are not ECE-approved and must not be used on public roads in any exterior application. Use on public roads will invalidate both the operating license and insurance coverage. - Авто та транспорт
wanted to see the headlight in the beginning of the video be finished..the way it was opened in wanted to see how he resealed it
You can put the entire headlight in the oven and the plastic cover will be easier to remove, just remove the light and igniter first or those will be damaged.
Hello, Can you tell me what are dimmensions of cold glue tool? I mean the width of sharp and distance between edges?
Will it work on the 08 onwards model years with AFL?
What if I have Xenon, any difference?
Hi, would using a standard heating gun help? Thanks in advance.
Yes, you can use it to re-heat the part where you are working on, just be careful not to point it in the same spot for too long / and not point at at the lens itself etc.
What temp are you setting the oven at? Im getting ready to do this exact thing
In general, 2 methods are used, with both methods, be careful and patient.
Method 1 is using a regular oven. Preheat the oven at 200 degrees Celsius. When ready, switch off the oven and place the headlight inside. Make sure that the headlight is not touching any metal of the oven by placing a cloth over the grid, for example. Leave the headlight in the oven for 10-15 minutes before opening it. If the headlight kit is not yet soft enough, put the headlight in the oven for a bit more time.
Method 2 is suitable for larger headlights that do not fit in a regular oven, or if your lovely wife absolutely does not allow car parts to be baked in her kitchen. A large cardboard box is used where hot air is blown through a heatgun. Make sure that the hot air of the heatgun does not blow directly to the headlight, place the headlight on small elevations so that the air can circulate properly through the box. We use a setting of 300 Degrees Celsius for 12-18 minutes / 1st lowest setting, depending on the size of the headlight.
Was this article helpful?
13
0
Will it work with the auto leveling system
Yes the auto leveling system will still work after the retrofit. :)
what a type of glue is it?
Hi, what Ø hane this rubber? 5mm?
You damaged the housing my friend
It is not a pro way to open the glass shield of the headlights