How to test Injector pump on a Kubota V3600T
Вставка
- Опубліковано 3 лип 2024
- bauertree.com/chippers/
This engine in on an Altec DC1317 chipper. Very common engine for Altecs.
Be sure not to get in the way of the nozzle spray. Its coming out at 1900 psi which is plenty enough pressure to cut right into you.
We are now located in Ashland Oregon and go by Bauer Tree Equipment, Inc
We sell a variety of tree equipment but specialized on older (pre-emission, pre-ecm) brush and tree chippers and stump grinders.
For more information please go to my website, email me or call directly at 541-930-2925
bauertree.com
And please subscribe to my page.
Thanks for watching. - Авто та транспорт
i am fighting a injector pump issue on a v2403 kabota and it sprays out fuel from the injector but wont start if its to cold , or wont restart once it gets warm, thinking it is just the plungers getting weak.
You don’t need hard lines fitted to the injector pump for bleeding it and for doing this test, it will just squirt out once the air has bled from the pump and will be easier to see, it’s also quicker than this set up.
Once you fit the hard lines you then bleed at the injectors.
I was testing to see if the individual pumps were generating enough pressure to operate the injectors.
Where did you find your lift pump ?
Available on ebay.
So what was the problem with the motor?
If i remember correctly it wasn't starting.
@@CalTreeEquip Thanks Matt! Do recall what prevented the start? It looks like you had a new set of injectors and the pump was working good.
That's not testing anything other than there's "some" fuel coming out of the pump, could be 122 bar or it could be 110 bar. and without an injector pop tester you have no idea at what pressure that injector pops at!
That is true. However, if the spray was weak I'd know I had problem. As it is, its pretty strong so I guessed the pump wasn't the problem, and it wasn't.
Just watch it again. Ya the injector popping off tells me there is adequate pressure generated.