How to remove Kubota V3600T Fuel Injector Pump
Вставка
- Опубліковано 3 жов 2024
- bauertree.com/...
Steps to remove the injector pump on a Kubota V3600T
-no need time anything (you are not affecting the cam position)
-remove injector lines completely (17mm and 19mm)
-remove inlet fuel line and bolt
-remove access port cap to throttle fork lever
-gently remove spring and secure it
-remove 8mm nut
-slid lever all the way to the left and pull away from the studs
-unbolt the pump in stages as pump will lift as its loosened (12mm)
-lift pump out of housing
-be careful with the shim and replace if damaged.
For a more complete video of how to remove these pump check out this video.
• Bobcat Fuel Injection ...
bauertree.com/...
THIS UNIT HAS BEEN SOLD, but we have lots of other chippers available.
We are located in Ashland Oregon and sell a variety of tree equipment but specialized in older (pre-emission, pre-ecm) brush and tree chippers and stump grinders.
For more information please go to my website, email me or call directly at 541-930-2925
bauertree.com
And please subscribe to my page.
Thanks for watching.
How to set the timing on the pump
Огромное спасибо за видео, нет никакой информации в бумажном виде, а благодаря вашему видео смог разобраться и снять ТНВД.
How do you remove the spring
Lifesaver!!!
Was a helpful tip thanks
Okay I'm working on the same thing but can't get the rail to slide down to take the nut off
There is a lever to the left. That is the manual lever to control the rail. Apparently those do jam up sometimes.