How to Replace Rear Engine Mount 2001-2005 Honda Civic

Buy Now!
New Engine Mount from 1AAuto.com 1aau.to/ib/1AEM...
This video shows you how to install a rear engine mount on your 2001-2005 Honda Civic. A shaking or vibrating engine, or bucking when changing gears are signs of worn engine mounts.
This process should be similar on the following vehicles:
2001 Honda Civic
2002 Honda Civic
2003 Honda Civic
2004 Honda Civic
2005 Honda Civic
Tools you will need:
• Pry Bar 1aau.to/odn/1AX...
• 12mm Socket 1aau.to/onc/1AX...
• 14mm Socket 1aau.to/onc/1AX...
• 17mm Socket 1aau.to/onc/1AX...
• 3/8 Inch Air Impact Gun
• 3/8 Inch Breaker Bar
• Ratchet 1aau.to/ooe/1AX...
• Socket Extensions 1aau.to/onc/1AX...
• Swivel
• Torque Wrench 1aau.to/ohG/1AX...
• Drill
• Jack Stands 1aau.to/ods/1AX...
Subscribe: / @trq
Check out our playlist:
Honda Civic 2001-2005 7th Generation: • Honda Civic 2001-2005 ...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money

[@tkaxxdavexx6874]

I replaced this mount hoping to fix a clunk I had when accelerating from a stop and when heavy braking.
I started noticing the clunk after I had the subframe out of the car when changing the transmission input shaft bearing. A year later, and after replacing nearly everything in the front end with no success, I finally found the issue. Apparently the subframe should be tightened with weight on the tires, not when jacked up. I loosened the 4 -17mm bolts holding it, let the car off the jack stands, then tightened them back up. Clunking is finally gone! Another thing I did was make sure the sway bar was aligned correctly, equal distance from the control arm on both sides - loosen the 2 bushing brackets and use a pry bar to wiggle it left or right as needed. I even paid a mechanic to diagnose the noise, he had me replacing parts unnecessarily. Thanks for video, hopefully my comment will also help someone out there, cheers!

[@lencranston8183]

I was looking for rear engine mount replacement help on my 2000 CRV AWD. I watched your video and of course, they are nothing alike, however, you did an excellent job making this video. Subscribing to your channel. Thank you.

[@tommyguns9008]

Why didn’t you use that right angle impact to loosen those bracket bolts? You used it to tighten them.

[@jessedelacruz243]

Is this a plastic mount?