I traveled between both! From hot hot texas days to freezing cold wyoming days. I think this thinsulate helps with both temps (hot and cold). It reflected a lot of sun heat off the van and it kept a lot of internally generated heat inside the van.
@@JeremiahLuke do you put the shiny part to the outside of the roof right under the plywood? I'm getti g the straight board type. Might use it inside too
I've seen a lot of people use insulation board! I think the main downside is rigidity + lack of breathing? I don't know much about this... but I seem to remember some people fearing sweating between the walls of your van.
@@JeremiahLuke I have been documenting... but between poor internet, being busy with the van, and a general lack of interest in technology... I haven't made a video 🤣🤣🤣 one day... I do put stuff up on Instagram 😇 Your videos are great!
What is your Instagram! (im @jeremiahlukebarnett if you don't want to put yours out here in the wild). I know that struggle...I don't know how many times I was struggling with a project or a part of a project and KNEW I should document it and then make a video with it but just wanted to get the damn work done and therefore didn't capture as much as I wanted. Oh well. Thank you :) appreciate you.
How did this insulation work out? Are you satisfied? I'm in the process of insulating my Transit, but man, the entire body of the van seems to be one massive thermal bridge, especially around the rear doors.
ohhh I loved this insulation. If not just because it is water resistant / proof! So, when i was in the process of discovering and fixing the leaks in my transit.. the insulation wasnt ruined! I am of the opinion that you can't really seal/insulate a van fully... its more about reducing all likely leaks of hot air as much as you can. i think thinsulate does a great job of it. The EZ cool over the thermal breaks was what Faroutride (popular van build reference material) recommended. It seemed to work... The rear doors... now that I never solved. If not just because of that massive crack in the back which allows ANY wind to come thru...i just got used to the fact that the front of the van was warm (where the heater was) and the rear was cold.
Hey there - I bought TWO rolls of 30x60 and I will probably come out with juuuust barely a little left over after I make window covers using the Thinsulate and EZ Cool.
You prolly dont give a shit but if you're bored like me during the covid times then you can stream all the new series on Instaflixxer. I've been watching with my brother these days :)
Weighing my different options. Easy is always good for a lady without much experience in building. I've been looking into sheeps wool too. Could the wool be tucked in with the material you used covering it? Am I going overboard?
I don't see why you couldn't tuck the wool and then cover with Thinsulate. Going overboard is always a matter of opinion...On one hand, I would highly recommend a solid attempt at insulting the van well for the sake of those really cold nights (and the hot ones too!). On the other hand, there is NO way that we will ever seal our vans to the point of them being toasty little boxes that hold all heat and never lose a bit. I am happy with my thorough installation with the Thinsulate and EZ Cool. I am not sure I could achieve much more if I tucked the wool stuff behind the Thinsulate. Just my thoughts though!
ahaha thank you for that - super nice to see / hear (I read it and somehow hear it). Thank you! Gonna make a 6-month review of living on the road and it will allow me to tap back into this humor. Stay tuned.
OK so thinsulate is very thin and not crazy high R-value so why not use a thin extruded pink foam board where a 1/2" sheet would be R3, or 1" pieces where you get R6? And maybe put a few pieces of wool insulation in those cavities. I'm getting read to go down this rabbit hole but Ive used 3M spray adhesive before and it's not very good, and that's on stuff that doesn't go shaking down the road. I hope it worked out for you, love the video.
I wanted the Thinsulate mostly because of its flexibility (easily working with grooves and curves and edges and cavities and then also for its hydrophobic properties (which I believe Foam board would share but not the wool?). Also, it was one of those things I had my heart set on earlier on in the process after reading those endless discussions where people are evenly divided down every possible line... I WHOLEHEARTEDLY agree with you on the 3M 90....what I didn't realize was that people most often use it simply to hold something in place UNTIL they cover it (insulation being the prime example)...Had I known that, I would have used contact cement in spray form for everything... Thanks for commenting :)
Are you living the n a cold climate or a warm climate what would the difference be for the application?
I traveled between both! From hot hot texas days to freezing cold wyoming days. I think this thinsulate helps with both temps (hot and cold). It reflected a lot of sun heat off the van and it kept a lot of internally generated heat inside the van.
@@JeremiahLuke do you put the shiny part to the outside of the roof right under the plywood? I'm getti g the straight board type. Might use it inside too
How satisfied are you with the insulating power of Thinsulate, now you have been through a couple of winters with it?
I loved loved loved it! It also is hydrophobic which is a huge plus imo
@@JeremiahLuke That's really good to know. Thanks!
are those speakers in the back wired up/functioning?
Yes! They are stock speakers that came with the van. They still work.
Hi my thinsulate came with black on both sides. Did I order the wrong kind or am I supposed to peel off one side? 🤔 🤦♀️
oh my goodness I don't know! It could be that they changed up the design? I wouldn't do any peeling unless it seems intended/easy...
What if you used thinsulate & insulation board (R3)?
I've seen a lot of people use insulation board! I think the main downside is rigidity + lack of breathing? I don't know much about this... but I seem to remember some people fearing sweating between the walls of your van.
You're a fun dude. Make me smile throughout the video! What will I mess up... I don't know what will happen... also me my whole van build 😄
Couldn't receive higher praise than that :)
haha you understand! How far along are you / are you gonna document the process?
@@JeremiahLuke I have been documenting... but between poor internet, being busy with the van, and a general lack of interest in technology... I haven't made a video 🤣🤣🤣 one day...
I do put stuff up on Instagram 😇
Your videos are great!
What is your Instagram! (im @jeremiahlukebarnett if you don't want to put yours out here in the wild).
I know that struggle...I don't know how many times I was struggling with a project or a part of a project and KNEW I should document it and then make a video with it but just wanted to get the damn work done and therefore didn't capture as much as I wanted. Oh well.
Thank you :) appreciate you.
@@JeremiahLuke My Instagram is @kathslan 🙂
@@JeremiahLuke no I have almost everything on video... its the making the video part 😅
How did this insulation work out? Are you satisfied? I'm in the process of insulating my Transit, but man, the entire body of the van seems to be one massive thermal bridge, especially around the rear doors.
ohhh I loved this insulation. If not just because it is water resistant / proof! So, when i was in the process of discovering and fixing the leaks in my transit.. the insulation wasnt ruined!
I am of the opinion that you can't really seal/insulate a van fully... its more about reducing all likely leaks of hot air as much as you can. i think thinsulate does a great job of it.
The EZ cool over the thermal breaks was what Faroutride (popular van build reference material) recommended. It seemed to work...
The rear doors... now that I never solved. If not just because of that massive crack in the back which allows ANY wind to come thru...i just got used to the fact that the front of the van was warm (where the heater was) and the rear was cold.
Hey mate, thanks for this video. What size roll did you get for your medium height transit?
Hey there - I bought TWO rolls of 30x60 and I will probably come out with juuuust barely a little left over after I make window covers using the Thinsulate and EZ Cool.
You prolly dont give a shit but if you're bored like me during the covid times then you can stream all the new series on Instaflixxer. I've been watching with my brother these days :)
@Reece Orlando yup, I've been watching on InstaFlixxer for months myself =)
I was wondering: did you install E-Z Cool before you put in the thinsulate?
I actually installed EZ Cool AFTER the Thinsulate. I did it on an ad-hoc basis (you can see here: ua-cam.com/video/sI4NjHZc0JU/v-deo.html)
Weighing my different options. Easy is always good for a lady without much experience in building. I've been looking into sheeps wool too. Could the wool be tucked in with the material you used covering it? Am I going overboard?
I don't see why you couldn't tuck the wool and then cover with Thinsulate. Going overboard is always a matter of opinion...On one hand, I would highly recommend a solid attempt at insulting the van well for the sake of those really cold nights (and the hot ones too!). On the other hand, there is NO way that we will ever seal our vans to the point of them being toasty little boxes that hold all heat and never lose a bit. I am happy with my thorough installation with the Thinsulate and EZ Cool. I am not sure I could achieve much more if I tucked the wool stuff behind the Thinsulate. Just my thoughts though!
@@JeremiahLuke Thank you for your response.
What about sound deadening?
there ya go! ua-cam.com/video/8ipaMw5uXEE/v-deo.html
Got a like just for the intro line
honestly if everyone just enjoyed the intros and nothing else I'd be happy... perhaps also the outros, I have fun with those too
Dude, you’re fucking amazing. You make such great entertaining content, keep it up
ahaha thank you for that - super nice to see / hear (I read it and somehow hear it). Thank you! Gonna make a 6-month review of living on the road and it will allow me to tap back into this humor. Stay tuned.
OK so thinsulate is very thin and not crazy high R-value so why not use a thin extruded pink foam board where a 1/2" sheet would be R3, or 1" pieces where you get R6? And maybe put a few pieces of wool insulation in those cavities. I'm getting read to go down this rabbit hole but Ive used 3M spray adhesive before and it's not very good, and that's on stuff that doesn't go shaking down the road. I hope it worked out for you, love the video.
I wanted the Thinsulate mostly because of its flexibility (easily working with grooves and curves and edges and cavities and then also for its hydrophobic properties (which I believe Foam board would share but not the wool?).
Also, it was one of those things I had my heart set on earlier on in the process after reading those endless discussions where people are evenly divided down every possible line...
I WHOLEHEARTEDLY agree with you on the 3M 90....what I didn't realize was that people most often use it simply to hold something in place UNTIL they cover it (insulation being the prime example)...Had I known that, I would have used contact cement in spray form for everything...
Thanks for commenting :)
Why music when talking?
sometimes it works sometimes it doesnt!
Great vid, makes a point of being right to the point and also made me really wanna watch 300 lol
hahah I cannot apologize for making you want to watch 300, in fact, I kinda wanna go watch it now too! haha
You make this world a better place! Never stop being you! Thanks for that! Subscribed and notifications ALL on!
This absolutely made my day. Thank you, Janos! For leaving such an encouraging message.
Thinsulate is good, Mineral wool is better, Areogel blankest are are best
0:16, 😆
😂
Shout out to the real hero: the kneepads
honestly the most supportive thing in this van build have been the pads
Try #999 today I am I mean we are no I mean I am... welcome
2:09, 😆