Dust Boot Shootout

In this video I'm doing a comparison of the two different dust boots that have been supplied to my by NymoLabs. If you have any questions about this machine please leave them in the comment section below. Thanks for watching.
I am very happy to announce that in cooperation with NymoLabs I now have a discount code link available. You can use this link to go to the NymoLabs website and get a whopping 10% discount on your total order.
www.nymolabs.com/discount/DAV...
Also, there may be a new CNC related livestream coming in the near future. Stay tuned.
Link to DesignSpark Mechanical Playlist - • DesignSpark Mechanical...
Get your Jenny Bits here - www.cadencemfgdesign.com/shop
Using these links to shop at Amazon.com help to support my channel.
Thank you.
Qfun Digital Caliper - amzn.to/3UDMQtR
1/4" shank 60° V-bit - amzn.to/3WOb4o9
3/8" Flush Trim Bit - amzn.to/3K3mInn
Titebond II Premium Wood Glue - amzn.to/3WWj5aw
Deft Spray Lacquer - amzn.to/3yFmGzA
The Official NymoLabs website: www.nymolabs.com
Join the NymoLabs CNC Users Group - / 691328529087335
#NymoLabs #NBX5040 #CNCrouter
Dave's Social Media Links
Facebook: / djgatton
Twitter: @DaveGatton
Instagram: davegatton
Join this channel to get access to perks:
/ @davegatton

[@DaveGatton]

Hey y'all.
I am very happy to announce that in cooperation with NymoLabs I now have a discount code link available. You can use this link to go to the NymoLabs website and get a whopping 10% discount on your total order.
www.nymolabs.com/discount/DAVE-JX0C7XR5
Also, there may be a new CNC related livestream coming in the near future. Stay tuned.

[@paulsmessyworkshop]

Dave, good comparison. Even though it is a little tougher to set up and adjust I
like the first style better. More like what I am used to.

[@RBallarddesigns]

Interesting results Dave!

[@DaveGatton]

Thanks for watching Solar Man. Much appreciated buddy.

[@ljgault]

Very interesting, I would have bet the second one would do much better.. It is what it is..

[@DaveGatton]

Thanks for watching Larry. I had high hopes for that one. The downward blowing air from the router is just too much for the vacuum to overcome. The first one works pretty well, but I'm sure I would run that one into something (clamp) pretty quickly. 😃

[@TunaSoda]

Not what I expected with the second one, you could see it pull the brushes in from the suction, it looked like it was gonna be fine

[@DaveGatton]

I was surprised too. I thought both dust boots would be pretty much the same. I think the problem is that the vacuum has to overcome the air blowing down from the router. The router blows the chips through the brushes.