MS03a. [Siemens Motion Control] TIA Portal Single Axis Control - Project Introduction [3/10]

[@davdmart8927]

You are the best! I just started my internship and they were doing an advanced simotion course. I didn’t understand most of what they were saying, now with your videos I can at least start learning the basics and I feel less lost. Thank you my friend, may life repay you for your generosity

[@electricalautomation]

Thanks my friend, I am glad the videos are help and hope you are enjoying them. Another series S120 video may be also helpful ua-cam.com/video/gN_g5qqyD6I/v-deo.html

[@Bigmallone]

very helpful thanks

[@fernandocadena_]

Many thanks for the video!

[@electricalautomation]

Glad it was helpful!

[@thanhao3252]

It's so helpful to me

[@electricalautomation]

Thanks for watching!

[@deathdeity1426]

Please , could trigger confirm button on control panel , through FB , some warning and error cannot AcK using MC_reset ,
Thanks for support..

[@electricalautomation]

Some faults from your drive hardware level may not be reset totally by using MC_Reset. But it is very specially, maybe focus on your drive hardware level fault, solve it.

[@elayniothmen8867]

Hi! can I use this video to configurate s1200?

[@electricalautomation]

Yes, it is similar. Enjoy

[@VATEKCA]

Hello
Sorry to bother you, but I have seen some of your videos and maybe you can help me
How can I place two independent motors, which are controlled by Sinamics S120 drives and PLC S71500,
in such a way that these motors work as if they were a single axis, rotating both motors in phase and frequency simultaneously and perfectly synchronized at all times.
I have believed that using Technological Objects and functions such as
TO_PositioningAxis (as speed master) and TO_SynchronousAxis (as speed Slave).
Motor 1 (as Speed Master)---->Motor 2 (as Speed Slave)
These two motors must rotate exactly the same as if they were a single axis, the machines would rotate in the same phase and frequency.
Can you tell me if there is any example in which you can guide me and be able to make this application.
Thanks and Regards

[@electricalautomation]

This video will help you ua-cam.com/video/hie46Yd37uI/v-deo.html, please also review the entire S120 videos ua-cam.com/play/PL762SfoJC-e9l5BALU0tJeJyM1ZraK1zE.html

[@mixtv6790]

could you please add caption for video. thanks

[@electricalautomation]

You can enable caption via 'CC' button under the video, also you can select 'auto translate'.