Subaru Impreza GRB STI - Fixing Steering Rack Pinion Oil Leaking
Вставка
- Опубліковано 5 гру 2020
- This is the two kit we purchased for rack repair.
1) 34191FE020 SEAL KIT A-GEAR BOX
2) 34190AG000 REPAIR KIT-GEAR BOX
#subaru #cars #carlover #learn #jdm
![08-17+ Subaru Impreza (Base, WRX and STI) Steering rack rebuild. [Frugal Garage EP5]](http://i.ytimg.com/vi/VJVJ_EoYNbg/mqdefault.jpg)
A picture is worth a thousand words! Excellent! Thanks for sharing your experience!
Thank you Felipe!!! Hope you enjoy our others video too!!! Do help us share our UA-cam channel to your friends!! It will really motivate us to make more videos!! Thanks!!
Amazing man. So resourceful and you did a great job. Saving thousands in repair costs as well. Did it perform as intended?
Yes it does🤗
thank you
Thank you... hope you enjoy the video🤗
Thank you for the detailed video ! What type of grease did you used ?
Thank you your comment, we using Ap3s Super Nova Grease
at least you could have put part number for people tying to rebuild Rack that would make more sense
@impulseMusic , Thank you for your comment; we have already inserted the part that we use in the description.
@@TNALMotor7 thanks for your friendly reply
if i just need the seal kit mentioned in the above comments, do you think the replacement would be possible with the rack still installed in the car??
It is possible to get it done on rack.. but it will be very hard for the process..
How did u get the entire rack down? Did u pull the lines from the rack first or did u pull the lines from the pump and reservoir side?
Hi @mrshaneo 369 we pull the lines from the rack 1st…🤗 hope I answer your question
If the fluid is leaking from where steering shaft can u just change the top seal and be good?
Basically it works… but it also depend on your shaft condition.. if is too bad, even you change the top seal it also won’t last you very long.. hope I answer your question
Doesent look much harder than rebuilding a hydraulic cylinder. To anyone attempting this put your seals in hot water they are much mpre malleable
is it possible if the valve is clogged by crushed debris from the vanes (rotor blade) of the power steering pump? because my car after changing the power steering it doesn't feel as light as before, and turning right is heavier than turning left. This incident occurred when the propeller was installed incorrectly by a fake mechanic when changing the pump seal, in the end I had to replace the entire pump, but after changing the pump it felt like the steering wheel was not as light as before. anyone understand and can provide input or help?
Hello there, base on your description, there’s a possibility of the air is trapped in the steering pump which happened to us before, so if this is the case… you can try jack up your car… start the engine… slowly turn left to the max, then wait for awhile…. follow by turn to the right to the max… continue this process for few times… see it will release the remaining air or not…. hopefully this will help you up!!!
I also had this issue with new rack: turning left is harder than turnung right (left hand drive model). According to subaru service manual, the different should be less than 20% (while testing the rack on the "table" (not in the car with engine running!)). But after ~300km I almost don't feel the different.
Can you post the parts and their numbers
Hello MrShaneo369 this is the 2 kits that we bought to fix the steering rack
1) 34191FE020 (SEAL KIT A-GEAR BOX )
2) 34190AG000 ( REPAIR KIT-GEAR BOX )
@@TNALMotor7 thanks appreciated